Question 1. Which of the following best describes the mapping between VLANs and IP subnets in a modern switched network?
One VLAN to many IP subnets
One IP subnet to one VLAN
One IP subnet to many VLANs
Varies with the model of Cisco Catalyst switch
Question 2. Which of following VLAN frame encapsulation types are configurable on a Cisco switch?
VTP
802.1Q
LLC
None of the above
Question 3. Which of the following depicts a VTP domain?
Switches share VLAN information; the boundary is defined by a Layer 3 device.
It can only create, delete, and modify local VLANs.
It advertises VLAN configuration information and can create, delete, and modify VLANs.
It restricts broadcast traffic to those trunks that must be used to reach the destination devices.
Question 4. A _____ stores VLAN information only in RAM.
VTP client
VTP domain
VTP pruning
VTP server
Question 5. Which VTP mode should a Cisco switch be set to if this switch is to add or delete VLANs to a management domain?
Transparent
Server
Auto
Client
Question 6. Which of the following is the closest to the root bridge?
Root port
Spanning Tree Protocol
Spanning-tree algorithm
Switch diameter
Question 7. What is the time spent in the listening and learning states called?
Forward delay
Forwarding state
Hello time
Learning state
Question 8. The time between each BPDU sent on a port is called which of the following?
Forwarding state
Hello time
Learning state
Listening state
Question 9. A term for when the port is administratively shut down is _____.
designated ports
disabled state
forward delay
forwarding state
Question 10. In the _____ state, the MAC address table is built but does forward user data frames.
forwarding
hello time
learning
listening
Question 11. Which contains a priority value and the MAC address?
Bridge priority
Bridge protocol data unit
Designated ports
Bridge ID
Question 12. VLAN is a logical group of ports, usually belonging to _____ to control the size of the broadcast domain.
a single IP subnet
multiple IP subnets
either a single IP subnet or to multiple IP subnets
none of the above
Question 13. Which command is used to determine whether inter-VLAN communication is functioning?
show vlan
ping
ipconfig
show interface
Question 14. Inter-VLAN routing _____ additional subnet broadcast addresses.
requires
does not require
sometimes requires
none of the above
Question 15. How many physical interfaces are required to perform inter-VLAN routing with traditional inter-VLAN routing?
One port per VLAN
Two ports per VLAN
Four ports per VLAN
No physical interface per VLAN.