Assignment: LAN Design Project Packet Tracer

Scenario:

You have been tasked with designing your new corporate network since they found out you have studied IP addressing, Cisco networking, and routing. Below is a screen shot of the topology for your network:

You are responsible for the following tasks: Design and Implement IPv4 addressing plan

Includes putting addresses on all PCs, switches, and routers Design and Implement basic configurations for Switch 1 and Switch 2 Hostnames, Management IP address for VLAN 1, enable secret password, line console password and Message of the Day Warning banner. Put proper default gateway address on Switch 1 and Switch 2.

Design and Implement basic configurations on all 3 routers:

Hostnames, IP addresses on proper interfaces, enable secret password, line console password and Message of the Day Warning banner.

Design and Implement SSH on switches

Create proper addressing on VLAN 1, usernames & passwords on Switch 1 and Switch 2 Design and Implement SSH on all 3 routers.

Create usernames & passwords on Corporate Router, ISP router and Branch office router

Design and Implement static routing on all 3 routers so that all networks are reachable.

Create proper static routes on routers to reach all other networks.

Details on Addressing:

You have been given the following major IP address:

NOTE: You will each have your own different major IP address that you need to subnet. In other words, everyone will have a slightly different problem!

You need to subnet that into 4 separate networks.

Network 1 subnet - Corporate LAN

Network 2 subnet - Connection between Corp Router G0/0 to ISP G0/0

Network 3 subnet - Connection between ISP Router G0/1 to Branch office Router G0/1 Network 4 subnet - Branch Office LAN

Put proper addressing on Corporate Router interfaces G0/0 and G0/1 Put proper addressing on ISP router G0/0 and G0/1

Put proper addressing on Branch Office Router G0/0 and G0/1

Turn on all interfaces on all 3 routers by issuing the no shutdown command for each interface

Put VLAN 1 ip address on Switch 1 - Should be address in Network 1 Corporate LAN subnet

Put VLAN 1 ip address on Switch 2 - should be address in Network 4 Branch office LAN subnet.

Put proper addressing, subnet mask and default gateway on PCs and Server in Corporate LAN. They should use addresses in Network 1 subnet.

Put proper addressing, subnet mask and default gateway on PCs in Branch Office LAN. They should use addresses from Network 4 subnet.
Configure static routing on all 3 routers.

Corporate router will need a route to Branch office LAN and connection between ISP and Branch router.

ISP router will need a route to Corporate LAN and Branch office LAN

Branch router will need a route to Corporate LAN and connection between ISP and Corp router.

TESTING & VALIDATION

Every device should be able to successfully ping every other device.

Routers should have complete routing tables - that is, they should "see" all 4 networks. I should be able to ssh into the switches.

COMMON DEVICE CONFIGURATION PARAMETERS -

enable secret command on all routers and switches should be cisco
line console password on all routers and switches should be class
ssh username admin        ssh password cisco123
message of the day banner   Warning! Stay out unless specifically authorized!

Put in address design. Have instructor check before implanting in Packet Tracer IP Subnetting Address Design: Fill out information for your four subnets

Subnet Number

Fill out table with proper addresses. Have instructor check before implementing in Packet Tracer.

Fill out table with proper addresses. Have instructor check before implementing in Packet Tracer.