Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

Oven Controller:

Assume that an oven has an electronic thermometer attached to circuitry with two outputs: one (H)  is asserted when the temperature is above h, and the other (L) is asserted when the temperature is below l. Design a circuit that will turn the oven on when the temperature falls below l; turn the oven off when the temperature rises above h; and when the temperature is between l and h, leave the oven in the condition it was in before l or h was reached. Design this controller as a state machine. 

prepare the HDL code and simulate the design. In your report, provide the HDL code, and show the simulation waveforms of your working design. In addition, show the RTL schematic resulted from the tool and report any interesting parameters such as highest clock frequency of the design.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M9121

Have any Question? 


Related Questions in Electrical & Electronics

1 how would you use amperes circuital law in differential

1. How would you use Ampere's circuital law in differential form to find the magnetic field adjacent to the current sheet? 2. If the current density on the infinite plane current sheet of Figure 4.2 were directed in the ...

Figure p77-4a shows a scheme to transmit two signals m1t

Figure P7.7-4a shows a scheme to transmit two signals m1(t) and m2(t) simultaneously on the same channel (without causing spectral interference). Such a scheme, which transmits more than one signal, is known as signal mu ...

A number equal to the sum of its coordinates is assigned to

A number equal to the sum of its coordinates is assigned to each point in a rectangular room having three of its contiguous edges as the coordinate axes. Draw a sketch of the constant-magnitude surfaces for the number fi ...

1 what is the direction of the magnetic field for a uniform

1. What is the direction of the magnetic field for a uniform plane wave having its electric field in the positive z-direction and propagating in the positive x-direction? 2. What is intrinsic impedance? What is its value ...

For a system specified by the transfer functionwrite sets

For a system specified by the transfer function write sets of state equations for DFII and its transpose, cascade, and parallel forms. Also write the corresponding output equations.

One of the attacks an intruder can apply to a simple cipher

One of the attacks an intruder can apply to a simple cipher like an additive cipher is called the ciphertext attack. In this type of attack, the intruder intercepts the cipher and tries to find the key and eventually the ...

Load flow calculation -in the power network shown below

Load Flow Calculation - In the power network shown below, node 1 is the slack bus, where the nodal voltage is defined as (1.0∠0 o ) pu, nodes 2, 4 and 5 are load buses, and node 3 is a generator bus where the voltage mag ...

1 suppose that a system is described by the impulse

1. Suppose that a system is described by the impulse response h(t) = 2sinc(t). Plot the magnitude of the frequency response of the system 2. Suppose that a system is described by the impulse response h(t) = 2sinc(t)sin(t ...

1 discuss the reasoning associated with the intuitive

1. Discuss the reasoning associated with the intuitive extension of the fields due to the time-varying current and charges of the Hertzian dipole based on time-varying electromagnetic phenomena. 2. Explain the reason for ...

Consider a deformation of a rectangular bar whose deformed

Consider a deformation of a rectangular bar whose deformed geometry is given as x 1 = αX 1 , x 2 = βX 2 , x 3 = βX 3 When the material is incompressible and St. Venant-Kirchhoff material properties are given as E = 600 M ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro