Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) prepare the brief note on integrate-and-dump filters.

2) prepare the concept of Tracking and describe Delay-Lock-Tracking.

3) A delay-line matched filter is to be constructed to match a 1023 code sequence. The code rate is 5 MCPs. What is the major delay characteristics required?

4) Describe in detail about the correlation receiver with AGC loop

5) prepare the brief notes on:

i. LOS loss and

ii. Absorptive losses

6) describe the direct sequence ranging system.

7) What is range error? Give the classification and describe briefly.

8) prepare short notes about the Jamming Margin Test setup in analog and digital information system.

9) What do you mean by sensitivity? describe the spread spectrum receiver sensitivity test setup.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M910630

Have any Question? 


Related Questions in Electrical & Electronics

An euler beam element shown in the figure is under a

An Euler beam element shown in the figure is under a uniformly distributed couple, C. Calculate the equivalent nodal forces. Using a simply supported beam under a uniform couple, show that the reaction forces are equal a ...

Show that the time-average value of the magnitude of the

Show that the time-average value of the magnitude of the Poynting vector given by (4.68) is one-half its peak value. For an antenna radiating a time-average power of 150 kW, find the peak value of the electric field inte ...

1 distinguish between bound electrons and free electrons in

1. Distinguish between bound electrons and free electrons in an atom. 2. Briefly describe the phenomenon of conduction. 3. State Ohms' law applicable at a point. How is it taken into account in Maxwell's equations? 4. Br ...

1 what is the difference between dm and dpcm2 what is the

1. What is the difference between DM and DPCM? 2. What is the problem with a speech signal that is compressed using the LPC method? 3. In transform coding, when a sender transmits the M matrix to a receiver, does the sen ...

1 the stream function for an incompressible two dimensional

1. The stream function for an incompressible, two dimensional flow field is For this flow field, sketch several streamlines. 2. A line vortex of strength K at (x, y) = (0, a) is combined with opposite strength vortex at ...

1 what is the steady-state equivalent of a line excited by

1. What is the steady-state equivalent of a line excited by a constant voltage source? What is the actual situation in the steady state? 2. Discuss the bounce-diagram technique of keeping track of the bouncing back and f ...

1 discuss the reciprocity associated with the transmitting

1. Discuss the reciprocity associated with the transmitting and receiving properties of an antenna. Can you think of a situation in which reciprocity does not hold? 2. What is the receiving pattern of a loop antenna? 3. ...

Answer the following questionsa how many output lines would

Answer the following questions. a. How many output lines would a 4 input decoder have? b. How many output lines would a 5 input decoder have? c. For an N-to-X decoder, specify X as a function of N (e.g. specify the numbe ...

1 implement a 3-to-8 decoder using not and and gates in

1. Implement a 3-to-8 decoder using NOT and AND gates in Logisim. Show that it is correct by showing it generates the same output as a 3-to-8 Decoder found in the Plexors menu of Logisim. 2. In Logisim, implement a 3-to- ...

An auto lift consists of 3602-cm-diameter ram that slides

An auto lift consists of 36.02-cm-diameter ram that slides in a 36.04-cm-diameter cylinder. The annular region is filled with oil having a kinematic viscosity of 0.00037 m 2  /s and a specific gravity of 0.85. If the rat ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro