Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) prepare down the various types of command words used in 8259a?

2) prepare down the operating modes of 8259a?

3) What do you mean by scan counter?

4) What is the output modes used in 8279?

5) prepare down the modes that are used in keyboard modes?

6) What are the modes used in display modes?

7) describe the use of modem control unit in 8251.

8) prepare down the register organization of 8257.

9) describe the function of DMA address register.

10) What is the use of terminal count register?

11) What is the function of mode set register in 8257?

12) prepare down the difference between the memories mapped I/O peripheral I/O.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M910959

Have any Question? 


Related Questions in Electrical & Electronics

An euler beam element shown in the figure is under a

An Euler beam element shown in the figure is under a uniformly distributed couple, C. Calculate the equivalent nodal forces. Using a simply supported beam under a uniform couple, show that the reaction forces are equal a ...

1 the functional frequency n of a stretched string is a

1. The functional frequency n of a stretched string is a function of the string length L, its diameter D, the mass density r, and the applied tensile force T. Suggest a set of dimensionless parameters relating these vari ...

The swap operation is one of the components of the modern

The swap operation is one of the components of the modern block ciphers. a. Swap the word (10011011)2. b. Swap the word resulting from part a. c. Compare the results of part a and part b to show that swapping is a selfin ...

1 distinguish message authentication and entity

1. Distinguish message authentication and entity authentication. 2. Alice signs the message she sends to Bob to prove that she is the sender of the message. Which of the following keys does Alice need to use? a. Alice's ...

A compute and plot the impulse response of the systemb

a. Compute and plot the impulse response of the system. b. Compute and plot the step response of the system. c. Compute and plot the response of the system to the input signal

Consider a deformation of a rectangular bar whose deformed

Consider a deformation of a rectangular bar whose deformed geometry is given as x 1 = αX 1 , x 2 = βX 2 , x 3 = βX 3 When the material is an incompressible Mooney-Rivlin hyperelastic material with A 10  = 80 MPa and A 01 ...

Solve problem using force equilibrium ie internal force

Solve Problem using force equilibrium; i.e., internal force caused by stress is equal to external force. Problem A force F is applied at the tip of the uniform bar element shown in the figure. The initial length and the ...

The rate at which metallic ions are electroplated from a

The rate at which metallic ions are electroplated from a dilute electrolytic solution onto a rotating disk electrode is usually governed by the mass diffusion rate of ions to the disk. This process is believed to be cont ...

1 why is it necessary to have the minus sign associated

1. Why is it necessary to have the minus sign associated with the time rate of increase of magnetic flux on the right side of Faraday's law? 2. What is electromotive force? 3. What are the different ways in which an emf ...

1 distinguish between centralized and decentralized p2p

1. Distinguish between centralized and decentralized P2P networks. 2. What are the advantages and disadvantages of a centralized P2P network? 3. What are the advantages and disadvantages of a decentralized P2P network? 4 ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro