Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1) What do you mean by tri-state devices?

problem 2) prepare down the advantages of using the Direct Memory Access.

problem 3) describe the purpose of the following commands in 8086.

(i) AAD,

(ii) RCL

problem 4) prepare down an 8086 assembly language program to multiply two 16 bit unsigned numbers to provide a 32 bit result. suppose that two numbers are stored in CX and DX.

problem 5) prepare down the important features of the 8254 Programmable interval timer.

problem 6) What do you mean by a Sample and Hold circuit?

problem 7) prepare down the advantages of the register indirect addressing mode in 8051 microcontroller?

problem 8) prepare down an 8051 program to monitor PI continuously for the value 63H. It must get out of the monitoring only if P1=63H.

problem 9) How is the microcontroller used for the traffic light control application?

problem 10) Distinguish microprocessor from microcontroller in system design.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M99013

Have any Question? 


Related Questions in Electrical & Electronics

1 find the minimum value of h for which the gate shown

1. Find the minimum value of h for which the gate shown will rotate counterclockwise if the gate cross section is (a) rectangular, 4 ft × 4 ft; (b) triangular, 4 ft at the base × 4 ft high. Neglect bearing friction. 2. A ...

1 what is a poynting vector what is its physical

1. What is a Poynting vector? What is its physical significance? 2. What is the physical interpretation of the surface integral of the Poynting vector over a closed surface? 3. Discuss how the fields far from a physical ...

A force f is applied at the tip of the uniform bar shown in

A force F is applied at the tip of the uniform bar shown in the figure. The displacement of the bar is given as u(X) = λX where λ is the principal stretch. The initial length and the cross-sectional area of the bar are, ...

The relationship between deformed and undeformed

The relationship between deformed and undeformed coordinates for the pure bending of a plane-strain solid is given as Compare the engineering strain and Lagrangian strain. Show that the two strain measures become identic ...

1 use the additive cipher with k 10 to encrypt the

1. Use the additive cipher with k = 10 to encrypt the plaintext "book". Then decrypt the message to get the original plaintext. 2. Encrypt the message "this is an exercise" using additive cipher with key = 20. Ignore the ...

An ideal transformer has a 150-turn primary and 750-turn

An ideal transformer has a 150-turn primary and 750-turn secondary. The primary is connected to a 240-V, 50-Hz source. The secondary winding supplies a load of 4 A at a lagging power factor (pf ) of 0.8. Determine (a) th ...

An infinite plane sheet lying in the plane carries a

An infinite plane sheet lying in the plane carries a current of uniform density Find the magnetic field intensities adjacent to the sheet and on either side of it. What is the polarization of the field?

Calculate the approximate diameter and length of stator

Calculate the approximate diameter and length of stator core, the number of stator slots and the number of conductors for a 20KW,400V,3 phase,4pole,1200rpm,delta connected induction motor. Bav=0.5T, Kw=0.82, ac=26000amp. ...

1 a determine the transfer function vosv1 s for the circuit

1. (a) Determine the transfer function Vo(s)/V1 (s) for the circuit shown below. (b) From the transfer function identify what type of filter it is. (c) Justify your answer of part b 2. (a) Draw the circuit of a free runn ...

A discuss asymptotic and bibo stabilities for the systems

a. Discuss asymptotic and BIBO stabilities for the systems described by the following transfer functions assuming that the systems are controllable and observable: b. Repeat part (a) for systems described by the followin ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro