Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) Compute the volume of 1 mole of a gas at 300k and 100 bar by using:

(a) Ideal gas law.

(b) Vander walls equation given a = 0.14Nm4/mol2 and     b=3x10-5m3/mol.

2) prepare down the important features of Rankine cycle and distinguish it from the regeneration cycle?

3) prepare about any two power cycles in detail.

4)(a) Wright about the construction of thermodynamics charts in detail.

(b) Deduce the Maxwell relations starting from fundamental property relations.

5) prepare detail notes on the following:

(a) State and path functions.

(b) Clausius Clapeyron equation.

(c) Excess properties.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913453

Have any Question? 


Related Questions in Electrical & Electronics

A sinusoid cosomega0t is a bandpass signal with zero

A sinusoid cos(ω0t) is a bandpass signal with zero bandwidth. This implies that the sampling rate that will allow reconstruction of this signal from its samples can be arbitrarily small. Show that this is indeed the case ...

A square block of surface area a on all sides is under pure

A square block of surface area A on all sides is under pure shear deformation due to the uniformly distributed load F on the top surface, as shown in the figure. The deformation of the block is such that the deformed coo ...

If the hertzian dipole in figure 919 is situated at a

If the Hertzian dipole in Figure 9.19 is situated at a distance from the corner and equidistant from the two planes, find the ratio of the radiation field at a point broadside to the dipole and away from the corner to th ...

1 how do you find the approximate value of the surface

1. How do you find the approximate value of the surface integral over a given surface? 2. How do you find the exact value of the surface integral? 3. Provide physical interpretations for the closed surface integrals of a ...

1 show the outline of a routing table for pastry with

1. Show the outline of a routing table for Pastry with address space of 16 and b = 2. Give some possible entries for each cell in the routing table of Node N21. 2. In a Pastry network using DHT, in which m = 4 and b = 2, ...

1 in one-dimensional dct if n 1 the matrix transformation

1. In one-dimensional DCT, if N = 1, the matrix transformation is changed to simple multiplication. In other words, M = T × p, in which T, p, and M are numbers (scalar value) instead of matrices. What is the value of T i ...

1 how do you find the exact value of the line integral2

1. How do you find the exact value of the line integral? 2. What is the physical significance of the line integral of the earth's gravitational field intensity? 3. What is the value of the line integral of the earth's gr ...

1 how do you find the work done in moving a test charge by

1. How do you find the work done in moving a test charge by an infinitesimal distance in an electric field? 2. What is the amount of work involved in moving a test charge normal to the electric field? 3. What is the phys ...

A line assumed to be infinitely long and of unknown

A line assumed to be infinitely long and of unknown characteristic impedance is connected to a line of characteristic impedance on which standing wave measurements are made. It is found that the standing wave ratio is 3 ...

Assignmentexercise 1 damping ratewe study the response of

Assignment Exercise 1: damping rate We study the response of the circuit of figure 1 to a step e(t). Figure 2 shows the output of the circuit as function of the time. The step signal during all this exercise. 1. Give the ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen