Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) prepare down Masons Gain formula.

2) prepare the analogous electrical elements in force voltage analogy for elements of mechanical translational system.

3) prepare down the analogous electrical elements in force current analogy for elements of mechanical translational system.

4) prepare down the force balance equation of m ideal mass element.

5) prepare down the force balance equation of ideal dashpot element.

6) prepare down the force balance equation of ideal spring element.

7) What do you mean by servomechanism?

8) Why negative feedback is invariably preferred in closed loop system?

9) prepare the differential equations governing the Mechanical system shown in fig. and determine the transfer function.

281_Mechanical system.jpg

10) Find out the transfer function Y2(S)/F(S) of the system shown in fig.

698_Mechanical system_1.jpg

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911011

Have any Question? 


Related Questions in Electrical & Electronics

1 implement the 2-to-4 decoder using 7404 not an 7808 and

1. Implement the 2-to-4 decoder using 7404 (NOT) an 7808 (AND) chips on your breadboard. 2. Implement the 2-to-4 decoder circuit with a 74139 chip on your breadboard. 3. Implement a 1-to-2 decoder in Logisim. Implement t ...

Charge is distributed uniformly with density within a

Charge is distributed uniformly with density within a spherical volume of radius a m and having its center at the origin. Using Gauss' law for the electric field, find the electric field intensity both inside and outside ...

1 state amperes force law as applied to current elements2

1. State Ampere's force law as applied to current elements. 2. Why is it not necessary for Newton's third law to hold for current elements? 3. What is the permeability of free space? What are its units? 4. Describe the m ...

1 what is the voltage reflection coefficient at the

1. What is the voltage reflection coefficient at the junction between two transmission lines? How are the current reflection coefficient and the voltage and current transmission coefficients related to the voltage reflec ...

Does the velocity distribution in example satisfy

Does the velocity distribution in Example satisfy continuity? Example A rotating shaft, as illustrated in Figure, causes the fluid to move in circular streamlines with a velocity that is inversely proportional to the dis ...

1 considering te modes in a dielectric slab guide specify

1. Considering TE modes in a dielectric slab guide, specify the fundamental mode and discuss the associated cutoff condition. 2. Compare the phenomenon at cutoff in a metallic waveguide with that at cutoff in an optical ...

Solve problem using the secant method do not use the

Solve Problem using the secant method. Do not use the incremental force method. Discuss about the convergence rate. Problem :- Consider a uniform bar with a constant Young's modulus, E = 100 MPa; cross-sectional area, A ...

Ohms law problemsquestion 1an alarm clock draws 05 a of

Ohm's Law Problems Question 1 An alarm clock draws 0.5 A of current when connected to a 120 volt circuit. Calculate its resistance. a) 150 ohms b) 120 ohms c) 60 ohms d) 240 ohms Question 2 If one 9 volt battery is used ...

Derive the 3 x 3 d matrix in equation for a two-dimensional

Derive the 3 X 3 [D] matrix in Equation for a two-dimensional MooneyRivlin material with three material parameters (A 10 , A 01 , and K). Use the perturbed Lagrangian method for near-incompressibility.

A signal is bandlimited to 12 khz the band between 9 and 12

A signal is bandlimited to 12 kHz. The band between 9 and 12 kHz has been corrupted by excessive noise to the point that the information within this band is nonrecoverable. Determine the minimum sampling rate for this si ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro