Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) prepare down the EMF equation of DC generator and describe each term?

2) Describe the critical speed of the DC shunt generator?

3) describe why the series motor must not be started on no load?

4) Specify the methods of the speed control of DC shunt motor?

5) describe the regulation of the transformer.

6) Specify the condition for maximum efficiency of a transformer.

7) describe what do you understand by all day efficiency? For which type of transformers all day efficiency is describeed.

8) Provide the applications of the CT and PT?

9) describe the kinds of the PMBL DC motors?

10) describe the application of tachogenerators.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913221

Have any Question? 


Related Questions in Electrical & Electronics

1 what is the directivity of a fictitious antenna that

1. What is the directivity of a fictitious antenna that radiates equally in all directions into one hemisphere? 2. How do you find the radiation fields due to an antenna of arbitrary length and arbitrary current distribu ...

In problem find the rate of discharge if the frictional

In Problem , find the rate of discharge if the frictional head loss in the pipe is 3.2 v2 /g where v is the flow velocity in the pipe. Problem:- Referring to the figure, assume the flow to be frictionless in the siphon. ...

1 in one-dimensional dct if n 1 the matrix transformation

1. In one-dimensional DCT, if N = 1, the matrix transformation is changed to simple multiplication. In other words, M = T × p, in which T, p, and M are numbers (scalar value) instead of matrices. What is the value of T i ...

1 why is it necessary to have the minus sign associated

1. Why is it necessary to have the minus sign associated with the time rate of increase of magnetic flux on the right side of Faraday's law? 2. What is electromotive force? 3. What are the different ways in which an emf ...

A hertzian dipole is situated parallel to a corner

A Hertzian dipole is situated parallel to a corner reflector, which is an arrangement of two plane, perfect conductors at right angles to each other, as shown by the crosssectional view in Figure 9.19. (a) Locate the ima ...

1 for an open-circuited line what would be the boundary

1. For an open-circuited line, what would be the boundary condition to be satisfied at the open circuit? 2. What is a standing wave? How do complete standing waves arise? Discuss their characteristics and give an example ...

1 a synchronous alternator is supplying 09 pu power to the

(1) A synchronous alternator is supplying 0.9 p.u. power to the grid when a temporary three-phase short occurs on the interconnector. The power angle curves are:- Pre-fault = 2.0 sin(delta) During fault = 0.5 sin(delta) ...

1 use the additive cipher with k 10 to encrypt the

1. Use the additive cipher with k = 10 to encrypt the plaintext "book". Then decrypt the message to get the original plaintext. 2. Encrypt the message "this is an exercise" using additive cipher with key = 20. Ignore the ...

A continuous belt passes upward through a chemical bath at

A continuous belt passes upward through a chemical bath at velocity v 0  and picks up a film of liquid of thickness h, density, ρ, and viscosity μ. Gravity tends to make the liquid drain down, but the movement of the bel ...

1 discuss the consequence of the frequency dependence of

1. Discuss the consequence of the frequency dependence of the phase velocity of a wave in a material medium. 2. What is loss tangent? Discuss its significance. 3. What is the intrinsic impedance of a material medium? Wha ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen