Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe how the design problems of the electrical machine are classified?

2) Describe the specific electric loading?

3) Specify the guiding factors for selecting the number of poles within the dc machine?

4) Specify the materials that are used for brushes within the dc machine?

5) prepare down the differences between the core and shell type transformers.

6) describe why the transformers are rated in the kVA?

7) Specify the benefits of the slip ring rotor over the cage rotor?

8) describe how the induction motor is developed for the best power factor?

9) describe what is meant by the short circuit ratio?

10) Specify the uses of the damper windings within the synchronous machine.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913280

Have any Question? 


Related Questions in Electrical & Electronics

If the resistance between the outside terminals of a linear

If the resistance between the outside terminals of a linear potentiometer is 10 kΩ, what is its resistance between the wiper (movable) arm and an outside terminal if the resistance between the wiper arm and the other out ...

What is the total rated capacity mw for this wind farm once

What is the total rated capacity (MW) for this wind farm once it is installed? Estimate the total actual electrical energy (kWh/yr) that can be generated in 1 average year based on the proposed wind turbines and given ca ...

Using branch-current analysis find the current through each

Using branch-current analysis, find the current through each resistor for the networks of given figure. The resistors are all standard values.

Explain the one memory portstructural hazards digand

Explain the "One Memory Port/Structural Hazards" dig.. and Explain why there are"DMEM" and "IFETCH" are in red?

A 3-phase 10 mva 11 kv generator with a solidly earthed

A 3-phase, 10 MVA, 11 kV generator with a solidly earthed neutral point supplies a feeder. The relevant impedances of the generator and feeder in ohms are as under:                                            Generator    ...

1 find the magnitudes of velocities va and vb in figure 325

1. Find the magnitudes of velocities v A and v B in Figure 3.25, where, theta = 20.0 degree and v tot = 5.88 m/s. 2. Find the components of v tot along the x and y axes in Figure 3.25, where theta = 22.5 degree and v tot ...

Design an inverting op-amp circuit with a gain whose

Design an inverting op-amp circuit with a gain whose magnitude is 10 VN using one 220 La resistor and another resistor no greater than 1 MΩ.

A particular pn junction for which the breakdown voltage is

A particular pn junction for which the breakdown voltage is 120 V, can dissipate 50 mW while maintain-ing its junction temperature at a value low enough to avoid permanent junction damage. What continu-ous reverse curren ...

The area in circular mils isa 1600 cmb 900 cmc 40000 cmd

The area in circular mils is a. 1600 CM b. 900 CM c. 40,000 CM d. 625 CM e. 7.75 CM f. 81 CM What is the diameter of each wire in inches?

Describe the microscopic structure of semiconductor

Describe the microscopic structure of semiconductor materials. What are the three most commonly used semiconductor materials?

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

A cola-dispensing machine is set to dispense 9 ounces of

A cola-dispensing machine is set to dispense 9 ounces of cola per cup, with a standard deviation of 1.0 ounce. The manuf

What is marketingbullwhat is marketing think back to your

What is Marketing? • "What is marketing"? Think back to your impressions before you started this class versus how you

Question -your client david smith runs a small it

QUESTION - Your client, David Smith runs a small IT consulting business specialising in computer software and techno

Inspection of a random sample of 22 aircraft showed that 15

Inspection of a random sample of 22 aircraft showed that 15 needed repairs to fix a wiring problem that might compromise

Effective hrmquestionhow can an effective hrm system help

Effective HRM Question How can an effective HRM system help facilitate the achievement of an organization's strate