Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) What do you mean by data communication? describe in detail.

2) prepare down the three criteria essential for the effective and efficient network?

3) prepare down the three fundamental characteristics that determine the effectiveness of data communication system?

4) prepare down the advantages of distributed processing.

5) describe why protocols are needed?

6) describe why standards are needed?

7) For n devices in the network, what is the number of cable links needed for mesh and ring topology?

8) prepare down the difference between a passive and an active hub?

9) prepare down the difference between peer-to-peer relationship and primary-secondary relationship.

10) Suppose six devices are arranged in mesh topology. How many cables are required? How many ports are required for each device?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911206

Have any Question? 


Related Questions in Electrical & Electronics

A ferromagnetic core with a relative permeability of 1500

A ferromagnetic core with a relative permeability of 1500 is shown in Figure P1-3. The dimensions are as shown in the diagram, and the depth of the core is 5 cm. The air gaps on the left and right sides of the core are 0 ...

A design a series ohmmeter using a 100-ma 1000-omega

a. Design a series ohmmeter using a 100-mA, 1000-Ω movement; a zero-adjust with a maximum value of 2 kΩ; a battery of 3 V; and a series resistor whose value is to be determined. b. Find the resistance required for full-s ...

Develop a computer simulation of an integrate-anddump

Develop a computer simulation of an integrate-anddump detector for antipodal baseband signaling based on (8.1). Generate AT or -AT randomly by drawing a uniform random number in [0, 1] and comparing it with 1/2. Add to t ...

For the transistors in the circuit in given figure the

For the transistors in the circuit in given figure, the parameters are: h FE  = 50, V BE  (on) = 0.7 V, and V A  = ∞. Using nodal analysis, determine the closed-loop current gain A if  = i o /i s .

A 1gw synchronous generator is connected to an infinite bus

A 1GW synchronous generator is connected to an infinite bus through a transmission line. The synchronous reactance of the generator is 9Ω and the inductive reactance of the transmission line is 3Ω. The infinite bus volta ...

A lathe is powered by a 50 hp electric motor and is running

A lathe is powered by a 5.0 HP electric motor and is running at 500. RPM. It is turning a 1.0 inch cast iron shaft with a depth of cut of 0.035 in. What is the maximum feed rate that can be used before the lathe stalls?

A 10 k omega and a 22 k omega resistor are connected in

A 1.0 k Ω and a 2.2 k Ω resistor are connected in parallel. There is a total of 100 mA through the parallel combination. How much voltage is dropped across the resistors?

Develop a verilog model of a pipelined circuit that

Develop a Verilog model of a pipelined circuit that computes the maximum of corresponding values in three streams of input values, a, b and c. The pipeline should have two stages: the first stage determines the larger of ...

A 480-v 100-kw 08-pf leading 50-hz four-pole y-connected

A 480-V 100-kW 0.8-PF leading 50-Hz four-pole Y-connected synchronous motor has a synchronous reactance of 1.8 W and a negligible armature resistance. The rotational losses are also to be ignored. This motor is to be ope ...

Parts a b and c of this problem should be done by

Parts (a), (b), and (c) of this problem should be done by inspection-that is, mentally. The intent is to obtain a solution without a lengthy series of calculations. For the network of given figure: a. What is the approxi ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

A cola-dispensing machine is set to dispense 9 ounces of

A cola-dispensing machine is set to dispense 9 ounces of cola per cup, with a standard deviation of 1.0 ounce. The manuf

What is marketingbullwhat is marketing think back to your

What is Marketing? • "What is marketing"? Think back to your impressions before you started this class versus how you

Question -your client david smith runs a small it

QUESTION - Your client, David Smith runs a small IT consulting business specialising in computer software and techno

Inspection of a random sample of 22 aircraft showed that 15

Inspection of a random sample of 22 aircraft showed that 15 needed repairs to fix a wiring problem that might compromise

Effective hrmquestionhow can an effective hrm system help

Effective HRM Question How can an effective HRM system help facilitate the achievement of an organization's strate