Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe the field components which are radiated from open end of the coaxial line?

2) prepare down the advantages of stepped dielectric lens antenna.

3) What do you mean by a biconical antenna?

4) What do you mean by a Lunenburg lens?

5) prepare down the advantages of lens antenna.

6) prepare down the uses of lens antenna.

7) Describe how spherical waves are produced?

8) Describe the characteristic impedance of biconical antenna in detail.

9) prepare down the expressions for voltage across feed points of the biconical antenna and current flowing through the surface of cone?

10) What do you understand by sect oral horn?

11) What is meant by pyramidal horn?

12) What do you mean by a back lobe radiation?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911190

Have any Question? 


Related Questions in Electrical & Electronics

1 is it meaningful to consider two different surfaces

1. Is it meaningful to consider two different surfaces bounded by a closed path to computethe two different currents on the right side of Ampere's circuital law to find around the closed path? 2. Discuss briefly the appl ...

Implement circuits in logisim that show whether or not the

Implement circuits in Logisim that show whether or not the operations AND, OR, XOR, NAND, NOR, and XNOR are commutative. This can be accomplished using circuits with only 3 inputs and 2 operations. 1. Create a table simi ...

Using the data of problem determine the velocity head of

Using the data of Problem, determine the velocity head of the fluid leaving the impeller. What pressure rise would result from such a velocity head? Problem :- Sea water, ρ = 64 lbm/ft3 , flows through the impeller of a ...

1 a synchronous alternator is supplying 09 pu power to the

(1) A synchronous alternator is supplying 0.9 p.u. power to the grid when a temporary three-phase short occurs on the interconnector. The power angle curves are:- Pre-fault = 2.0 sin(delta) During fault = 0.5 sin(delta) ...

Consider two bar elements under a force at the tip using

Consider two bar elements under a force at the tip. Using the displacement controlled method, plot the load-displacement curve (F vs. u 2  and u 3 ). Increase the tip displacement u 3  up to 1.0 m by ten equal increments ...

A clean 15--efficient module stc 1 m2 in size has its own

A clean, 15-%-efficient module (STC), 1 m 2 in size, has its own 90% efficient inverter. Its NOCT is 44° C and its rated power degrades by 0.5%/° C above the 25° C STC. a. What would its STC rated power be? b. Find the k ...

1 what is the difference between dm and dpcm2 what is the

1. What is the difference between DM and DPCM? 2. What is the problem with a speech signal that is compressed using the LPC method? 3. In transform coding, when a sender transmits the M matrix to a receiver, does the sen ...

1 a 16-scale model of a torpedo is tested in a water tunnel

1. A 1/6-scale model of a torpedo is tested in a water tunnel to determine drag characteristics. What model velocity corresponds to a torpedo velocity of 20 knots? If the model resistance is 10 lb, what is the prototype ...

1 state the divergence theorem and discuss its application2

1. State the divergence theorem and discuss its application. 2. What is the divergence of the curl of a vector? 3. Summarize Maxwell's equations in differential form. 4. Are all Maxwell's equations in differential form i ...

1 implement the 2-to-4 decoder using 7404 not an 7808 and

1. Implement the 2-to-4 decoder using 7404 (NOT) an 7808 (AND) chips on your breadboard. 2. Implement the 2-to-4 decoder circuit with a 74139 chip on your breadboard. 3. Implement a 1-to-2 decoder in Logisim. Implement t ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen