Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1:

In the PCM system, a 7 bit encoder is employed. Assume each level represents the voltage of 1 V, What is the range of encoder? Find the quantization error on account of PCM if the voltage of 126.80V involved.

problem 2:

prepare down comprehensive notes on:

a) Pulse duration system

b) Pulse rate system

c) Pulse code system.

problem 3:

prepare down briefly about digital transmission system in satellite telemetry.

problem 4:

Illustrate a telemetry system where measured variable is shown as the function of AC or DC voltage.

problem 5:

Sketch of pneumatic transmitter and describe?

problem 6:

prepare down comprehensive notes on the following:

a) Multiplexing

b) FDM

c) IRIG standard.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911204

Have any Question? 


Related Questions in Electrical & Electronics

Question 1consider the following wireless receiver chain

Question 1: Consider the following wireless receiver chain consisting of a low noise amplifier (LNA), bandpass filter and mixer, as depicted below. The LNA receives its input signal from an antenna. a) If the input noise ...

Consider a microphone intended for use in a music recording

Consider a microphone intended for use in a music recording studio. Determine a suitable frequency response (lowpass, highpass, bandpass, or bandstop) for the microphone, and provide suitable values (such as δp and ωs) t ...

Compute and plot the solution of the difference equation yn

Compute and plot the solution of the difference equation y[n] þ y[n 1] = 2x[n] þ x[n 1], where x[n] = 0.8n u[n] assuming zero initial conditions. Moreover, verify your answer (a) by examining if the derived solution sati ...

1 a rectangular block of concrete 3 ft times 3ft times 6 in

1. A rectangular block of concrete 3 ft × 3ft × 6 in. has its 6- in. side half buried at the bottom of a lake 23 ft deep. What force is required to lift the block free of the bottom? What force is required to maintain th ...

1 what is the permittivity of free space what are its

1. What is the permittivity of free space? What are its units? 2. Describe the electric field due to a point charge. 3. How do you find the electric field intensity due to a continuous charge distribution? 4. How is curr ...

Question 1a for the circuit shown in figure 1 sketch the

Question 1. (a) For the circuit shown in FIGURE 1 sketch the voltage waveform across the secondary winding of the transformer. On the same diagram sketch the load voltage waveform. The sketches should take into account d ...

1 define the parts of flow specification in intserv2

1. Define the parts of flow specification in IntServ. 2. Distinguish between guaranteed services and controlled-load services in IntServ. 3. IntServ is normally called a destination-based service. Explain the reason. 4. ...

1 define wavelength how is it related to the phase

1. Define wavelength. How is it related to the phase constant? 2. What is the relationship between frequency, wavelength, and phase velocity? What is the wavelength in free space for a frequency of 15 MHz? 3. What is the ...

1 define the radiation resistance of an antenna2 why is the

1. Define the radiation resistance of an antenna. 2. Why is the expression for the radiation resistance of a Hertzian dipole not valid for a linear antenna of any length? 3. Explain why power lines are not effective radi ...

Does a large bolt-to-joint stiffness ratio increase or

Does a large bolt-to-joint stiffness ratio increase or decrease the possibility of fatigue failure of the bolt and why? Name at least three bolt, thread, or bolt and thread configurations which can improve the fatigue re ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro