Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) Why do we require Transmission inter connections?

2) With a neat circuit diagram describe the operation of single phase full wave voltage source converter and draw the relevant wave forms for ac voltage, ac current.

3) prepare down the advantages and disadvantages of current source converters over voltage source converters.

4) With neat diagrams describe the variations of voltage stability limit of a radial line with load and load power factor and describe how you extend the limit by reactive shunt compensation.

5) With a block diagram describe the functional control scheme for the TSC-TCR type static var generator.

6) Design the block diagram of basic static var compensator and derive the expression for the variation of amplitude variation of the terminal voltage against amplitude variation of power system voltage.

7) Compare the STATCOM and SVC taking at least six points into account

8) With a neat circuit diagram describe a basic Thyristor Switched Series Capacitor scheme and describe the operation.

9) prepare down the limitations on loading capability of transmission assets.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M910648

Have any Question? 


Related Questions in Electrical & Electronics

1 what is the voltage reflection coefficient at the short

1. What is the voltage reflection coefficient at the short circuit for a short-circuited line? 2. Can the transmitted wave current at the junction between two transmission lines be greater than the incident wave current? ...

Consider a nonlinear elastic uniaxial bar element under tip

Consider a nonlinear elastic uniaxial bar element under tip force F = 100 N shown in Figure. The stress-strain relation is given in terms of Cauchy stress and engineering strain in the deformed geometry: σ11 = Eε 11 . Us ...

1 why is it that the distances r1 and r2 in the phase

1. Why is it that the distances r 1 and r 2 in the phase factors in equations (8.47a) and (8.47b) cannot be set equal to r, but the same quantities in the amplitude factors can be set equal to r? 2. What is an array fact ...

Tasks1learn how to use opendss2open and execute the epri

Tasks 1. Learn how to use OpenDSS 2. Open and execute the EPRI Test Circuit 24 model 3. Develop base case data sets of bus voltages and power flows 4. Provide analysis of the base case model: a. Feeder voltage profiles b ...

1 discuss the application of the gradient concept for the

1. Discuss the application of the gradient concept for the determination of unit vector normal to a surface. 2. How would you find the rate of increase of a scalar function along a specified direction by using the gradie ...

The relationship between deformed and undeformed

The relationship between deformed and undeformed coordinates for the pure bending of a plane-strain solid is given as Compare the engineering strain and Lagrangian strain. Show that the two strain measures become identic ...

1 discuss briefly the motional emf concept2 what is lenzs

1. Discuss briefly the motional emf concept. 2. What is Lenz's law? 3. How would you orient a loop antenna in order to obtain maximum signal from an incident electromagnetic wave which has its magnetic field linearly pol ...

1 a synchronous alternator is supplying 09 pu power to the

(1) A synchronous alternator is supplying 0.9 p.u. power to the grid when a temporary three-phase short occurs on the interconnector. The power angle curves are:- Pre-fault = 2.0 sin(delta) During fault = 0.5 sin(delta) ...

1 derive the weak form of a two-dimensional steady-state

1. Derive the weak form of a two-dimensional, steady-state heat transfer problem. 2. Derive the weak form of a simply supported beam problem.

1 discuss the reasoning associated with the intuitive

1. Discuss the reasoning associated with the intuitive extension of the fields due to the time-varying current and charges of the Hertzian dipole based on time-varying electromagnetic phenomena. 2. Explain the reason for ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro