Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1) Why do we prefer optical fiber communication for long distance transmission?

problem 2) Compute the transmission distance over which the optical power will attenuate by a factor of 10 for the fiber with loss of O.2dB/km. Assume the typical relation of fiber attenuate on loss.

problem 3) What do you mean by single mode fiber. What is the importance of cut off wavelength concern with it?

problem 4) How and why do stimulated scattering effects occur in optical fibers?

problem 5) Where do you use distributed feedback laser (DFB) structures?

problem 6) What do you mean by Single longitudinal Mode (SLM) laser?

problem 7) State quantum efficiency and the responsivity of a photodiode.

problem 8) Dry fibers have acceptable losses over a spectral region extending from 1.3 to 1.6 pm. find out the capacity of a WDM system covering this entire region using 40 Gb/s channels spaced apart by 50 GHz i) Describe briefly frequency chirping in optical communication.

problem 9) prepare down the four desirable properties of a tunable optical filter.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M98462

Have any Question? 


Related Questions in Electrical & Electronics

1 define the radiation resistance of an antenna2 why is the

1. Define the radiation resistance of an antenna. 2. Why is the expression for the radiation resistance of a Hertzian dipole not valid for a linear antenna of any length? 3. Explain why power lines are not effective radi ...

1 if the plate shown is inclined at an angle as shown what

1. If the plate shown is inclined at an angle as shown, what are the forces F x  and F y  necessary to maintain its position? The flow is frictionless. 2. A steady, incompressible, frictionless, two-dimensional jet of fl ...

1 when a doublet is added to a uniform stream so that the

1. When a doublet is added to a uniform stream so that the source part of the doublet faces the stream, a cylinder flow results. Plot the streamlines when the doublet is reversed so that the sink faces the stream. 2. A 2 ...

1 what is a divergence meter how does it help visualize the

1. What is a divergence meter? How does it help visualize the behavior of the divergence of a vector field? 2. Provide two examples of physical phenomena in which the divergence of a vector field is nonzero. 3. State the ...

A voltage source vt 100 cos2pi50 t v is applied to a

A voltage source v(t) = 100 cos(2π50 t) [V] is applied to a nonlinear load, resulting in non-sinusoidal current: i(t) = 4 + 10 cos(2π50 t +30°) + 20 cos (4π50 t +45°) [A]. Determine: (a) the power absorbed on the load, ( ...

1 what is the significance of a b times c 02 is it

1. What is the significance of A · B × C = 0? 2. Is it necessary for the reference vectors a 1 , a 2 , and a 3 to be an orthogonal set? 3. State whether a 1 , a 2 , anda3 directed westward, northward, and downward, respe ...

Microelectronics1 what regions are heavily doped n to form

Microelectronics 1. What regions are heavily doped n+ to form ohmic contacts? 2. On the plot to the right. label the horzontal and vertical axis. Indicate the triode and square law regions. The square law region of secon ...

Data at a rate of 1 million pulses per second are to be

Data at a rate of 1 million pulses per second are to be transmitted over a certain communications channel. The unit step response g(t) for this channel is shown in Fig. P2.7-1. a. Can this channel transmit data at the re ...

Question 1a for the circuit shown in figure 1 sketch the

Question 1. (a) For the circuit shown in FIGURE 1 sketch the voltage waveform across the secondary winding of the transformer. On the same diagram sketch the load voltage waveform. The sketches should take into account d ...

1 does sip need to use the service of rtp explain2 we

1. Does SIP need to use the service of RTP? Explain. 2. We mentioned that SIP is an application-layer program used to provide a signaling mechanism between the caller and the callee. Which party in this communication is ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro