Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) Describe the master control relay with an application.

2) Describe a process requiring nesting of two subroutines.

3) Describe the operation of SKIP function layout and prepare a MCR function PLC operation layout.

4) What is the purpose of JUMP function? prepare down the advantages of JUMP Instruction?

5) Describe the process of controlling a basic two axis Robot with a PLC sequencer.

6) prepare down the advantages of matrix functions.

7) prepare brief notes on:

i) ONS and CLR function

ii) PLC analog modules

iii) PLD modules

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M910645

Have any Question? 


Related Questions in Electrical & Electronics

A signal is bandlimited to 12 khz the band between 10 and

A signal is bandlimited to 12 kHz. The band between 10 and 12 kHz has been so corrupted by excessive noise that the information in this band is nonrecoverable. Determine the minimum sampling rate for this signal so that ...

1 apply the law of conservation of mass to an element in a

1. Apply the law of conservation of mass to an element in a polar coordinate system and obtain the continuity equation for a steady, two-dimensional, incompressible flow. 2. In cartesian coordinates, show that may be wri ...

A clean 15--efficient module stc 1 m2 in size has its own

A clean, 15-%-efficient module (STC), 1 m 2 in size, has its own 90% efficient inverter. Its NOCT is 44° C and its rated power degrades by 0.5%/° C above the 25° C STC. a. What would its STC rated power be? b. Find the k ...

The spacing a between the plates of a parallel-plate

The spacing a between the plates of a parallel-plate waveguide is equal to 5 cm. The dielectric between the plates is free space. If a generator of fundamental frequency 1800 MHz and rich in harmonics excites the wavegui ...

1 discuss the evolution of the half-wave dipole from an

1. Discuss the evolution of the half-wave dipole from an open-circuited transmission line. 2. Justify the approximations involved in evaluating the integrals in the determination of the radiation fields due to the half-w ...

1 a synchronous alternator is supplying 09 pu power to the

(1) A synchronous alternator is supplying 0.9 p.u. power to the grid when a temporary three-phase short occurs on the interconnector. The power angle curves are:- Pre-fault = 2.0 sin(delta) During fault = 0.5 sin(delta) ...

A vertical cylindrical tank closed at the bottom is

A vertical, cylindrical tank closed at the bottom is partially filled with an incompressible liquid. A cylindrical rod of diameter d i (less than tank diameter, d 0 ) is lowered into the liquid at a velocity V. Determine ...

1 how do you find the work done in moving a test charge by

1. How do you find the work done in moving a test charge by an infinitesimal distance in an electric field? 2. What is the amount of work involved in moving a test charge normal to the electric field? 3. What is the phys ...

A clean 15--efficient module stc 1 m2 in size has its own

A clean, 15-%-efficient module (STC), 1 m2 in size, has its own 90% effi- cient inverter. Its NOCT is 44° C and its rated power degrades by 0.5%/° C above the 25° C STC. a. What would its STC rated power be? b. Find the ...

The size d of droplets produced by a liquid spray nozzle is

The size d of droplets produced by a liquid spray nozzle is thought to depend upon the nozzle diameter D, jet velocity V, and the properties of the liquid ρ, μ, and σ. Rewrite the relation in dimensionless form. Take D, ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro