Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) What do you mean control system?

2) describe open loop control system in detail with suitable ex.

3) Describe non- touching loop in detail.

4) describe transfer function in detail.

5) What are the basic elements used for modelling mechanical rotational system?

6) prepare down the name of two types of electrical analogous for mechanical system.

7) What do you mean by block diagram? describe in detail.

8) What is the basis for framing the rules of block diagram reduction technique?

9) What is a signal flow graph? describe it with suitable ex.

10) What do you understand by transmittance?

11) What do you mean by sink and source?

12) describe closed loop control system in detail.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911007

Have any Question? 


Related Questions in Electrical & Electronics

1 in kademlia assume m 4 and active nodes are n4 n7 and

1. In Kademlia, assume m = 4 and active nodes are N4, N7, and N12. Where is the key k3 stored in this system? 2. In Chord, assume the size of the identifier space is 16. The active nodes are N3, N6, N8, and N12. Show the ...

1 a rectangular block of concrete 3 ft times 3ft times 6 in

1. A rectangular block of concrete 3 ft × 3ft × 6 in. has its 6- in. side half buried at the bottom of a lake 23 ft deep. What force is required to lift the block free of the bottom? What force is required to maintain th ...

1 list the components of a traffic conditioner in diffserv2

1. List the components of a traffic conditioner in DiffServ. 2. Is the flow label in IPv6 more appropriate for IntServ or DiffServ?

A large amount of energy e is suddenly released in the air

A large amount of energy E is suddenly released in the air as in a point of explosion. Experimental evidence suggests the radiusr of the high-pressure blast wave depends on time t as well as the energy E and ρ the densit ...

1 what are the energy densities associated with the

1. What are the energy densities associated with the electric and magnetic fields? 2. An infinite plane sheet lying in the plane carries a current of uniform density Find the currents crossing the following straight line ...

1 energy calculationsbuilding sf 20000 sfelectric rateuse

1. Energy Calculations Building SF = 20,000 sf Electric Rate: Use MTSU Utility Rate Schedule - Seasonal Rates Lighting: 2 watts/sf hours of operation = 19 hours per day Motors: One water pump motor, 80% efficient, runnin ...

Consider a microphone intended for use in a music recording

Consider a microphone intended for use in a music recording studio. Determine a suitable frequency response (lowpass, highpass, bandpass, or bandstop) for the microphone, and provide suitable values (such as δp and ωs) t ...

Question 1 design a suitable double -layer lap winding for

Question 1) Design a suitable double -layer lap winding for a 6-pole dc armature with 18 slots and two coil sides per slot. Give values of front-pitch, brack-pitch and commutator pitch. Draw the developed diagram and sho ...

1 a synchronous alternator is supplying 09 pu power to the

(1) A synchronous alternator is supplying 0.9 p.u. power to the grid when a temporary three-phase short occurs on the interconnector. The power angle curves are:- Pre-fault = 2.0 sin(delta) During fault = 0.5 sin(delta) ...

1 in one-dimensional dct if n 1 the matrix transformation

1. In one-dimensional DCT, if N = 1, the matrix transformation is changed to simple multiplication. In other words, M = T × p, in which T, p, and M are numbers (scalar value) instead of matrices. What is the value of T i ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen