Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) What is meant by reverberation time? Deduce the Sabine’s formula for reverberation time.

2)(a) Deduce the expression for depression at free end of the  cantilever due to load. (Suppose the weight of cantilever is negligible)

(b) Cantilever of length 50cm fixed at one end is depressed by 20mm at loaded end. Compute the depression at the distance of 40cm from fixed end.

3)(a) Derive an expression for depression for rectangular beam loaded in such a way that bending is uniform.

(b) Describe experimental setup used to find out Young’s modulus of the rectangular beam loaded on its either side.

4)(a) describe in detail Davisson and Germer experiment for determination of wavelength of electrons.

(b) What is the physical importance of wave function?

5)(a) Derive the expression for energy of the electron in the infinitely deep potential well having one dimension.

(b) find out the energy difference between first and second quantum state for the free electron in solid of 1m cube.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913641

Have any Question? 


Related Questions in Electrical & Electronics

The single-phase full-bridge inverter from fig 62a has a

The single-phase full-bridge inverter from Fig. 6.2a has a square-wave voltage across a series R-L load. The switching frequency is 50 Hz, the DC input voltage is 250 V, and the load is a serial connection of R = 10 Ω an ...

Question 1 design a suitable double -layer lap winding for

Question 1) Design a suitable double -layer lap winding for a 6-pole dc armature with 18 slots and two coil sides per slot. Give values of front-pitch, brack-pitch and commutator pitch. Draw the developed diagram and sho ...

A the highest frequency in the spectrum x omega fig p81-8a

a. The highest frequency in the spectrum X (ω) (Fig. P8.1-8a) of a bandpass signal x (t) is 30 Hz. Hence, the minimum sampling frequency needed to sample x (t) is 60 Hz. Show the spectrum of the signal sampled at a rate ...

1 the tank is accelerated upward at a uniform rate does the

1. The tank is accelerated upward at a uniform rate. Does the manometer level go up or down? 2. Glass viewing windows are to be installed in an aquarium. Each window is to be 0.6 m in diameter and to be centered 2 m belo ...

1 repeat the previous problem without the assumption that

1. Repeat the previous problem without the assumption that the velocity in the heating section is negligible. The ratio of the flow area of the heating section to the chimney flow area is R. 2. Consider a 4-cm pipe that ...

Microelectronics1 what regions are heavily doped n to form

Microelectronics 1. What regions are heavily doped n+ to form ohmic contacts? 2. On the plot to the right. label the horzontal and vertical axis. Indicate the triode and square law regions. The square law region of secon ...

1 how many points can we have in a dht with m 102 explain

1. How many points can we have in a DHT with m = 10? 2. Explain the problems we encounter if we use IP addresses as the node identifiers in a DHT. 3. Explain two strategies used for storing an object in DHT-based network ...

Consider the simple rc circuit shown in fig p23-3 let r 1

Consider the simple RC circuit shown in Fig. P2.3-3. Let R = 1 kΩ and C = 1 nF. (a) Find the system transfer function. (b) Plot the magnitude and phase responses. (c) Show that a lowpass signal x(t) with bandwidth W « 10 ...

1 for the coaxial cable of example 69 employing air

1. For the coaxial cable of Example 6.9 employing air dielectric, find the ratio of the outer to the inner radii for which the characteristic impedance of the cable is 75 Ω. 2. Using the general solutions for the complex ...

In a leaky bucket used to control liquid flow how many

In a leaky bucket used to control liquid flow, how many gallons of liquid are left in the bucket if the output rate is 5 gal/min, there is an input burst of 100 gal/min for 12 s, and there is no input for 48 s?

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen