Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1: What is the relationship between the data rate and the distance which the data can reliably travel on the EIA interface?

problem 2: What does the mechanical specifications, electrical specifications and the functional specifications of EIA-232 describe?

problem 3: According to EIA-449 standard, what is the fundamental difference between Category I pins and Category II pins?

problem 4: Draw the time domain graph for the bit pattern 10110110 as it would show on an RS-422 circuit. Suppose a 1 is 5 volts and a 0 is -5 volts. Draw the complement as well.

problem 5: By using the data in the proceeding problem, suppose that the first and last bits are corrupted by 1 volt of noise. Draw both lines and draw the difference of the complement from the signal.

problem 6: By using RS-423(unbalanced) mode, find out the data rate if the distance between DTE and DCE is 1000 feet?

problem 7: By using RS-423(balanced) mode, find out the data rate if the distance between DTE and DCE is 1000 feet?

problem 8: How much enhancement in data rate can be accomplished over 1000 feet if we move from RS-423 to RS-422?

problem 9: If 0.5 V of noise corrupts a bit on an RS-422 circuit, how many volts would be 1 required to the complementary bit?

problem 10: In which kind of a signal does bit rate equivalents the baud rate?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M97247

Have any Question? 


Related Questions in Electrical & Electronics

1 when a doublet is added to a uniform stream so that the

1. When a doublet is added to a uniform stream so that the source part of the doublet faces the stream, a cylinder flow results. Plot the streamlines when the doublet is reversed so that the sink faces the stream. 2. A 2 ...

Suppose that a discrete-time system is specified by the

Suppose that a discrete-time system is specified by the transfer function Compute and plot a. The step response of the system b. The impulse response of the system c. The response of the system to the input signal

Load flow calculation -in the power network shown below

Load Flow Calculation - In the power network shown below, node 1 is the slack bus, where the nodal voltage is defined as (1.0∠0 o ) pu, nodes 2, 4 and 5 are load buses, and node 3 is a generator bus where the voltage mag ...

Ohms law problemsquestion 1an alarm clock draws 05 a of

Ohm's Law Problems Question 1 An alarm clock draws 0.5 A of current when connected to a 120 volt circuit. Calculate its resistance. a) 150 ohms b) 120 ohms c) 60 ohms d) 240 ohms Question 2 If one 9 volt battery is used ...

In communication channels transmitted signal is propagated

In communication channels, transmitted signal is propagated simultaneously by several paths of varying lengths. This causes the signal to reach the destination with varying time delays and varying gains. Such a system ge ...

For each of the following baseband signals i mt cos 1000t

For each of the following baseband signals (i) m(t) = cos 1000t, (ii) m(t) = 2cos 1000t + cos 2000t, and (iii) m(t) = cos 1000t cos 3000t: a. Sketch the spectrum of m(t). b. Sketch the spectrum of the DSB-SC signal m(t) ...

1 in kademlia assume m 4 and active nodes are n4 n7 and

1. In Kademlia, assume m = 4 and active nodes are N4, N7, and N12. Where is the key k3 stored in this system? 2. In Chord, assume the size of the identifier space is 16. The active nodes are N3, N6, N8, and N12. Show the ...

1 what would be the voltage and current standing wave

1. What would be the voltage and current standing wave patterns for an open-circuited line? 2. Discuss the variation with frequency of the input reactance of a short-circuited line and its application in the determinatio ...

1 describe the phasor technique of solving a differential

1. Describe the phasor technique of solving a differential equation for the sinusoidal steady-state solution. 2. State Coulomb's law. To what law in mechanics is Coulomb's law analogous? 3. What is the definition of the ...

A cryptographic hash function needs to be second preimage

A cryptographic hash function needs to be second preimage resistant, which means that given the message M and the message digest d, we should not be able to find any other message, M′, whose digest is d. In other words, ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro