Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

Q1. When the AVR is defective, if additional loads come on will the generator be capable to take it? describe how do you test, reverse power trip, high current trip and preferential trip?

Q2. What do you mean by residual magnetism? Illustrate where it is important?

Q3. At times, if you change the running direction of an E/R blower (from supply to the exhaust) it trips. describe why?

Q4. Does a current flow via a capacitor?

Q5. Describe the unit for the capacitance?

Q6. What do you mean by neutral?

Q7. Illustrate the difference between the neutral and earth?

Q8. describe why is reverse power protection is needed?

Q9. describe why is this reverse power used rather than reverse current in the alternators?

Q10. Illustrate the meaning of excitation in the alternator?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911377

Have any Question? 


Related Questions in Electrical & Electronics

Research quarterly may 1979 reports on a study of impulses

Research Quarterly, May 1979, reports on a study of impulses applied to the ball by tennis rackets of various construction. Three measurements on ball impulses were taken on each type of racket. For a Classic (wood) rack ...

Given a satellite altitude and desired illumination spot

Given a satellite altitude and desired illumination spot diameter on the earth surface, use MATLAB to determine the antenna aperture diameter and maximum gain to give the desired spot diameter.

A 220-v three-phase six-pole 50-hz induction motor is

A 220-V three-phase six-pole 50-Hz induction motor is running at a slip of 3.5 percent. Find: (a) The speed of the magnetic fields in revolutions per minute (b) The speed of the rotor in revolutions per minute (c) The sl ...

A for the network of given figure determine the value of r

a. For the network of given figure, determine the value of R for maximum power to R. b. Determine the maximum power to R. c. Plot a curve of power to R versus R for R equal to ¼   and 2 times the value obtained in part ( ...

Suppose it is possible to determine the wear rate

Suppose it is possible to determine the wear rate analytically, that is, by using formulas that establish the relation between temperatures and wear rate. However, the engineer is not sure how closely the analytical meth ...

A low-pass filter is to be designed to pass frequencies in

A low-pass filter is to be designed to pass frequencies in the 0 to 12 kHz range. The gain of the amplifier is to be +10 at the low frequency and change by no more than 10 percent over the frequency range. In addition, t ...

For the network of given figure find the theacutevenin

For the network of given figure, find the Thévenin equivalent circuit for the network external to the load resistor R L .

Find the energy stored in the capacitor and inductor of

Find the energy stored in the capacitor and inductor of given problem. Problem Assume that the voltage across each capacitor and the current through each inductor have reached their final values Find the current I 1  and ...

Write the given assignmentmechanical energy is supplied to

Write the given assignment. Mechanical energy is supplied to a d.c. generator at the rate of 4200 J/s. The generator delivers 32·2 A at 120 V. (i) What is the percentage efficiency of the generator ? (ii) How much energy ...

An industrial electric circuit is powered by a two-prong

An industrial electric circuit is powered by a two-prong polarized outlet through a feeder. The resistance of the neutral wire is 1.0Ω. The ground resistance at the service transformer is 20Ω. The chassis of the circuit ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

A cola-dispensing machine is set to dispense 9 ounces of

A cola-dispensing machine is set to dispense 9 ounces of cola per cup, with a standard deviation of 1.0 ounce. The manuf

What is marketingbullwhat is marketing think back to your

What is Marketing? • "What is marketing"? Think back to your impressions before you started this class versus how you

Question -your client david smith runs a small it

QUESTION - Your client, David Smith runs a small IT consulting business specialising in computer software and techno

Inspection of a random sample of 22 aircraft showed that 15

Inspection of a random sample of 22 aircraft showed that 15 needed repairs to fix a wiring problem that might compromise

Effective hrmquestionhow can an effective hrm system help

Effective HRM Question How can an effective HRM system help facilitate the achievement of an organization's strate