Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) What do you mean by sampled data control system?

2) Mention (Shanon’s) sampling theorem.

3) What do you mean by periodic sampling?

4) What do you understand by hold circuits?

5) prepare down the problems encountered in a practical hold circuits?

6) What are the methods available for stability analysis of sampled data control system?

7) What are state variables?

8) describe state space in detail.

9) What do you mean by phase variables?

10) What is a state vector?

11) describe Acquisition time in detail.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911041

Have any Question? 


Related Questions in Electrical & Electronics

1 complete the missing steps in the evaluation of the

1. Complete the missing steps in the evaluation of the integral in equation (9.39a). 2. Find the time-average power required to be radiated by a half-wave dipole in order to produce an electric field intensity of peak am ...

What are the two impairments caused by windowing what

What are the two impairments caused by windowing? What window characteristic is most related to each impairment? How is the effect of each impairment reduced? Can either window impairment be entirely eliminated? Explain ...

A continuous-time signal x t deltat 12 is sampled at

A continuous-time signal x (t) = Δ((t = 1)/2) is sampled at three rates: 10, 2, and 1 Hz. Sketch the resulting sampled signals. Because x (t) is timelimited, its bandwidth is infinite. However, most of its energy is conc ...

Load flow calculation -in the power network shown below

Load Flow Calculation - In the power network shown below, node 1 is the slack bus, where the nodal voltage is defined as (1.0∠0 o ) pu, nodes 2, 4 and 5 are load buses, and node 3 is a generator bus where the voltage mag ...

1 the tank is accelerated upward at a uniform rate does the

1. The tank is accelerated upward at a uniform rate. Does the manometer level go up or down? 2. Glass viewing windows are to be installed in an aquarium. Each window is to be 0.6 m in diameter and to be centered 2 m belo ...

A module with 40 cells has an idealized rectangular i-v

A module with 40 cells has an idealized, rectangular I-V curve with I SC = 4 A and V OC = 20 V. If a single cell has a parallel resistance of 5Ω and negligible series resistance, draw the I-V curve if one cell is complet ...

Data at a rate of 1 million pulses per second are to be

Data at a rate of 1 million pulses per second are to be transmitted over a certain communications channel. The unit step response g(t) for this channel is shown in Fig. P2.7-1. a. Can this channel transmit data at the re ...

A number equal to the sum of its coordinates is assigned to

A number equal to the sum of its coordinates is assigned to each point in a rectangular room having three of its contiguous edges as the coordinate axes. Draw a sketch of the constant-magnitude surfaces for the number fi ...

A force f is applied at the tip of the uniform bar element

A force F is applied at the tip of the uniform bar element shown in the figure. The initial length and the cross-sectional area of the bar are, respectively, A 0  and L 0 . The elastic modulus of the material is E. Calcu ...

1 repeat the previous problem without the assumption that

1. Repeat the previous problem without the assumption that the velocity in the heating section is negligible. The ratio of the flow area of the heating section to the chimney flow area is R. 2. Consider a 4-cm pipe that ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen