Ask Question, Ask an Expert

+61-413 786 465

info@mywordsolution.com

Ask Civil Engineering Expert

Task

Choose any three (3) of the following topics and prepare a response as instructed.

Topic 1

In 1000 words or less, provide a comprehensive review of travel demand management presenting its contrasts to travel supply management. The advantages and disadvantages of these two transport management strategies should be described citing examples and references. Include illustrations where appropriate.

Topic 2

Stopping sight distance (SSD) is the sight distance required by a driver to see a hazard in the road ahead, react, and then stop in time before impacting the hazard. It is determined by the following formula:

SSD = RTV/3.6 + V2/(254(d+0.01a))

A road authority has been using a driver reaction time of 1.5 seconds, and a coefficient of deceleration of 0.46 in its road designs. They have been asked to increase the driver reaction to 2 seconds and reduce the coefficient of deceleration to 0.36, to be consistent with the rest of the country.

You are required to write a technical note of 800 words or less to qualitatively explain the cost/ financial implications that this will have on modifying existing road network. In your response, you have been specifically requested to discuss the impact of the new SSD requirements on curved road sections.

Topic 3

An existing arterial road will be bypassed by a high-speed, high-mobility motorway (freeway). This has created an opportunity to "return the arterial road to the community". You are required to prepare a written strategy of no more than 1000 words describing four (4) methods to improve the access/amenity of the road. In your response you must be particularly mindful of induced traffic demand which may contravene the project objectives. The strategy must be well justified.

Topic 4

"Speed zones must be self enforcing"

Using three (3) examples, explain how road design features can assist in self-enforcing a low-speedroad to a nominated speed limit (ie. 10-60km/h). You can discuss more than speed limit value if desired. In your answer, you must include risk compensation/ homeostasis theory. Word limit is 1000 words.

Topic 5

Compare and contrast four-way traffic signal controlled intersections versus four-way roundabouts. In your response, discuss the safety implications of each as well as the traffic performance implications. Word limit is 500 words.

It is re-emphasised that you are to complete three (3) topics only, NOT all five.

Civil Engineering, Engineering

  • Category:- Civil Engineering
  • Reference No.:- M91779525
  • Price:- $80

Priced at Now at $80, Verified Solution

Have any Question?


Related Questions in Civil Engineering

Task details the client is doing masters in civil

Task Details: The client is doing Masters in Civil Engineering. He needs a Technical Paper on Earthquake pertaining to Geology and Rock Mechanics. There should be a through discussion of Earthquake in relation to the men ...

Aimthis assignment aims to demonstrate the structural

Aim: This assignment aims to demonstrate the structural design requirements of a glazed façade in a multi-storey building. Among other requirements, the glazed façade is required to comply with Australian Standard AS 204 ...

Masonry design assignmentquestion 1 - derivation of seismic

MASONRY DESIGN ASSIGNMENT Question 1 - Derivation of seismic actions on building a) Determine the storey seismic weights (Wi) for each suspended level of the building, hence the seismic weight (Wt) of the entire building ...

Assessment taskpractical investigationinstructions- it is

Assessment Task Practical Investigation Instructions: - It is very important that you read these instructions. - The hardcopy of the Assignment report, with the Assignment cover sheet, should be submitted to the Assignme ...

The drainage system of a cantilever wall shown in below

The drainage system of a cantilever wall shown in below figure, became blocked after a heavy rainstorm and the groundwater level, which was originallybelow the base, rose to1.5 (m) below the surface. Determine the stabil ...

1 aimthe assignment aims to develop the ability to analyse

1. Aim The assignment aims to develop the ability to analyse, evaluate, research plan and manage a major building project through individual and group participation (ideally 4-6 people).Refer to vUWS for the DA plans and ...

Assignment -ewb design report format - cover page - the as

Assignment - EWB Design Report Format - Cover page - The as EWB project Table of content Introduction about -EWB and CRDT (Cambodian Rural development team) Background about Cambodia - Economic, Weather, People - living ...

Assignmenta continuous three spans beam with

Assignment A continuous three spans beam with centre-to-centre distance of 6 m supports 150 mm thick one-way slabs as shown below. The beams have clear spans of 8 m, 9 m, and 8 (face-to-face of 400 mm square columns). Th ...

Aimthis assignment aims to demonstrate the structural

Aim: This assignment aims to demonstrate the structural design requirements of a glazed façade in a multi-storey building. Among other requirements, the glazed façade is required to comply with Australian Standard AS 204 ...

Masonry design assignmentquestion 1 - derivation of seismic

MASONRY DESIGN ASSIGNMENT Question 1 - Derivation of seismic actions on building a) Determine the storey seismic weights (Wi) for each suspended level of the building, hence the seismic weight (Wt) of the entire building ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As