Ask Electrical & Electronics Expert

Structure and use of PNP transistor:

The figure opposite is a schematic presentation of a PNP transistor related to two voltage sources. To construct the transistor conduct appreciable current (on the order of 1 mA) from E to C, VEB have to be above a minimum value occasionally considered to like the cut-in voltage. The cut-in voltage is generally about 600 mV for silicon BJTs at room temperature but can be different depending upon the type of transistor and its biasing. This applied voltage results the upper P-N junction to 'turn-on' permitting a flow of holes from the emitter into the base. In active mode, the electric field lay between the emitter and the collector (caused by VCE) causes the majority of these holes to cross the lower P-N junction into the collector to make the collector current IC. The remainder of the holes again combines with electrons, the majority carriers in the base, forming a current through the base connection to make the base current, IB. As displayed in the diagram, the emitter current, IE, is the total transistor current that is the sum of the other terminal currents (that is., IB=IB+IC).

In the figure, the arrows presenting current point in the direction of conventional current - the flow of holes is in similar direction of the arrows since holes carry positive electric charge. The ratio of the collector current to the base current is termed as the DC current gain, in active mode. This gain is generally 100 or more, but robust circuit designs do not depend upon the exact value. The value of this gain for DC signals is considered to as hFE, and the value of this gain for AC signals is considered to as hfe. Though, when there is no specific frequency range of interest, the symbol β is employed.

It should as well be noted that the emitter current is related to VEB exponentially. At room temperature, increment in VEB by approximately 60 mV increases the emitter current by a factor of 10. Since the base current is approximately proportional to the collector and emitter currents, they vary in similar way.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M9517335

Have any Question?


Related Questions in Electrical & Electronics

Question 1for the ce amplifier in figure 1 given the

Question 1 For the CE amplifier in Figure (1), given the following component parameters: Parameter Value β DC , β AC 150 V BE 0 . 7 V V CC 12 V R C 820 ? R E 1 100 ? R E 2 220 ? R 1 20 k? R 2 5 . 2 k? R L 100 k? C 1 , C ...

Question -i a star-connected three-phase synchronous

Question - (i) A star-connected, three-phase synchronous induction motor takes a current of 10 amps from a 415 volt supply at unity power factor when supplying a steady load. If the synchronous reactance is 5 ohms/phase ...

1 a name the three major groups of contamination and

1. (a) Name the three major groups of contamination and briefly describe their physical characteristics. (b) Where do the above contamination types come from? Give one example of each. 2. Name two processes metrics which ...

Question 1 in the voltage regulator circuit in figure p221

Question 1: In the voltage regulator circuit in Figure P2.21, V 1 = 20 V, V Z = 10 V, R i = 222Ω and P z (max) = 400 mW. (a) Determine I L, I z , and I L , if R L = 380Ω. (b) Determine the value of R L , that will establ ...

Summative assessmentin 2017 sej101 assessment will consist

Summative Assessment In 2017 SEJ101 assessment will consist of nine tasks that will develop a portfolio of your assessed work. Throughout the trimester you will have the opportunity for feedback on all nine tasks before ...

1 a name the three major groups of contamination and

1. (a) Name the three major groups of contamination and briefly describe their physical characteristics. (b) Where do the above contamination types come from? Give one example of each. 2. Name two processes metrics which ...

1 a name the three major groups of contamination and

1. (a) Name the three major groups of contamination and briefly describe their physical characteristics. (b) Where do the above contamination types come from? Give one example of each. 2. Name two processes metrics which ...

Case studythis assignment consists of a written report of

CASE STUDY This assignment consists of a written report of approximately 1000 words and any diagrams in which you are asked to critically compare different process methods used to achieve the same result and show an awar ...

Problem 1 a two-phase servomotor has rated voltage applied

Problem 1: A two-phase servomotor has rated voltage applied to its excitation winding. The torque speed characteristic of the motor with Vc = 220 V, 60 Hz applied to its control phase winding is shown in Fig.1. The momen ...

Electrical engineering questions -q1 two ideal voltage

Electrical Engineering Questions - Q1. Two ideal voltage sources designated as machines 1 and 2 are connected, as shown in the figure below. Given E 1 = 65∠0 o V, E 2 = 65∠30 o V, Z = 3Ω. Determine if Machine 1 is genera ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As