Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) Describe the kinds of the errors in detail.

2) describe the generalized measurements system and its functional elements with the help of the Block diagram.

3) describe the working principle of a piezo-electric transducer with the help of neat sketch.

4) Describe the method of measuring the force using the strain gauge load cell.

5) a) Specify the three laws of thermocouples. describe in detail.

b) Describe how the thermocouple is used to measure the temperature.

6) Describe the construction and working of the hot wire anemometer. describe in detail.

7) Describe the components of the mechanical system and their electrical analogues.

8) Describe the steps included in the construction of the single flow path.

9) Using the Routh criterion compute the stability of system whose characteristic equation is S5+2S4+10S3+10S2+5S+4=0

10) a) describe how to find the gain margin and phase margin from Bode plots.

b) Specify the methods that are available for analyzing the stability of systems.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913421

Have any Question? 


Related Questions in Electrical & Electronics

1 are both ah and esp needed for ip security why or why

1. Are both AH and ESP needed for IP security? Why or why not? 2. What are the two protocols discussed in this chapter that provide security at the transport layer? 3. What is IKE? What is its role in IPSec? 4. What is t ...

Consider a deformation of a rectangular bar whose deformed

Consider a deformation of a rectangular bar whose deformed geometry is given as x 1 = αX 1 , x 2 = βX 2 , x 3 = βX 3 When the material is incompressible and St. Venant-Kirchhoff material properties are given as E = 600 M ...

A compute and plot the impulse response of the systemb

a. Compute and plot the impulse response of the system. b. Compute and plot the step response of the system. c. Compute and plot the response of the system to the input signal

1 energy calculationsbuilding sf 20000 sfelectric rateuse

1. Energy Calculations Building SF = 20,000 sf Electric Rate: Use MTSU Utility Rate Schedule - Seasonal Rates Lighting: 2 watts/sf hours of operation = 19 hours per day Motors: One water pump motor, 80% efficient, runnin ...

1 what is meant by the dominant mode why are waveguides

1. What is meant by the dominant mode? Why are waveguides designed so that they propagate only the dominant mode? 2. Why is the dimension b of a rectangular waveguide generally chosen to be less than or equal to one-half ...

Ohms law problemsquestion 1an alarm clock draws 05 a of

Ohm's Law Problems Question 1 An alarm clock draws 0.5 A of current when connected to a 120 volt circuit. Calculate its resistance. a) 150 ohms b) 120 ohms c) 60 ohms d) 240 ohms Question 2 If one 9 volt battery is used ...

1 if the plate shown is inclined at an angle as shown what

1. If the plate shown is inclined at an angle as shown, what are the forces F x  and F y  necessary to maintain its position? The flow is frictionless. 2. A steady, incompressible, frictionless, two-dimensional jet of fl ...

In a kademlia network with m 4 we have five active nodes

In a Kademlia network with m = 4, we have five active nodes: N2, N3, N7, N10, and N12. Find the routing table for each active node (with only one column).

A circular loop antenna of radius 1 m in free space carries

A circular loop antenna of radius 1 m in free space carries a uniform current (a) Calculate the amplitude of the electric field intensity at a distance of 10 km in the plane of the loop. (b) Calculate the radiation resis ...

Write the state equations for the systems depicted in fig

Write the state equations for the systems depicted in Fig. P10.5-1. Determine a new state vector w such that the resulting state equations are in diagonalized form. Write the output y in terms of w. Determine in each cas ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro