Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe what do you understand by electric drive?

2) Specify the fundamental torque equation of the motor load system.

3) Sketch the speed-torque features of the D.C shunt motor?

4) Specify the benefits of DC chopper drives.

5) describe the plugging in 3- phase induction motor.

6) describe the several applications of the stator voltage control scheme?

7) Compare and contrast the current source and voltage source inverter.

8) describe what do you understand by the v/f control?

9) describe the advantages of the digital control techniques?

10) Specify the factors that are affecting the selection of drives.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913203

Have any Question? 


Related Questions in Electrical & Electronics

In a chord network with m 4 node n2 has the following

In a Chord network with m = 4, node N2 has the following finger-table values: N4, N7, N10, and N12. For each of the following keys, first find if N2 is the predecessor of the key. If the answer is no, find which node (th ...

1 what is a boundary condition how do boundary conditions

1. What is a boundary condition? How do boundary conditions arise and how are they derived? 2. Summarize the boundary conditions for the general case of a boundary between two arbitrary media, indicating correspondingly ...

A dc pump connected to a pv module runs a garden water

A dc pump connected to a PV module runs a garden water fountain. The pump I -V curve and the hourly I -V curves for the module are shown. Once the pump starts running, it needs 8 V to keep spinning. At what time in the m ...

A causal n-point moving-average filter has impulse response

A causal N-point moving-average filter has impulse response h[n] = (u[n]-u[n-N])/N. a. Determine a constant coefficient difference equation that has impulse response h[n]. b. Write a MATLAB function that will compute the ...

A periodic signal xt is expressed by the following fourier

A periodic signal x(t) is expressed by the following Fourier series: a. Sketch the amplitude and phase spectra for the trigonometric series. b. By inspection of spectra in part (a), sketch the exponential Fourier series ...

The performance of a journal bearing around a rotating

The performance of a journal bearing around a rotating shaft is a function of the following variables: Q, the rate of flow lubricating oil to the bearing in volume per unit time; D, the bearing diameter; N, the shaft spe ...

1 for the force field f x2ay find the approximate value of

1. For the force field F = x 2 ay, find the approximate value of the line integral of F from the origin to the point (1, 3, 0) along a straight line path by dividing the path into ten equal segments. 2. For the force fie ...

In problem find the rate of discharge if the frictional

In Problem , find the rate of discharge if the frictional head loss in the pipe is 3.2 v2 /g where v is the flow velocity in the pipe. Problem:- Referring to the figure, assume the flow to be frictionless in the siphon. ...

Given an rtp packet with the first 8 hexadecimal digits as

Given an RTP packet with the first 8 hexadecimal digits as (86032132)16, answer the following questions: a. What is the version of the RTP protocol? b. Is there any padding for security? c. Is there any extension header? ...

For each of the following baseband signals i mt cos 1000t

For each of the following baseband signals (i) m(t) = cos 1000t, (ii) m(t) = 2cos 1000t + cos 2000t, and (iii) m(t) = cos 1000t cos 3000t: a. Sketch the spectrum of m(t). b. Sketch the spectrum of the DSB-SC signal m(t) ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro