Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe what is forward bias and reverse bias in a PN junction?

2) Sketch the VI characteristics of Zener Diode.

3) Transform 29610 to hexadecimal number.

4) describe what is multiplexer? Provide some of its applications.

5) describe what is ALE? describe its applications.

6) What is meant by the microprocessor? describe the power supply and clock frequency of 8085.

7) Describe the CMP B instruction in 8085.

8) Compare and contrast the CALL and PUSH instructions.

9) describe the modes that are used in the display modes?

10) Specify how many ports are needed for the keyboard interfacing?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913562

Have any Question? 


Related Questions in Electrical & Electronics

1 what is snells law2 what is meant by the plane of

1. What is Snell's law? 2. What is meant by the plane of incidence? Distinguish between the two different linear polarizations pertinent to the derivation of the reflection and transmission coefficients for oblique incid ...

1 discuss the physical interpretation of amperes circuital

1. Discuss the physical interpretation of Ampere's circuital law in differential form for the simple case of 2. State Ampere's circuital law in differential form for the general case of an arbitrary magnetic field. How i ...

Consider a simple shear deformation of a square whose

Consider a simple shear deformation of a square whose deformed geometry is given as x 1 = X 1 + αX 2 , x 2 = X 2 , x 3 = X 3 When the material is incompressible and St. Venant-Kirchhoff material properties are given as E ...

Implement circuits in logisim that show whether or not the

Implement circuits in Logisim that show whether or not the operations AND, OR, XOR, NAND, NOR, and XNOR are commutative. This can be accomplished using circuits with only 3 inputs and 2 operations. 1. Create a table simi ...

The device in the schematic diagram below is a viscosity

The device in the schematic diagram below is a viscosity pump. It consists of a rotating drum inside of a stationary case. The case and the drum are concentric. Fluid enters at A, flows through the annulus between the ca ...

A 9 kva 208 v l-l 3-phase y connected stator synchronous

A 9 kVA, 208 V (L-L), 3-phase Y connected stator, synchronous generator has a stator resistance of 0.1 ohm per phase, and a synchronous resistance of 5.6 ohm per phase. The generator is driven by a diesel engine, and is ...

1 what is the particular advantageous characteristic

1. What is the particular advantageous characteristic associated with the unit vectors in the Cartesian coordinate system? 2. How do you find a vector perpendicular to a plane? 3. How do you find the perpendicular distan ...

Consider a bar element as shown in the figure the

Consider a bar element as shown in the figure. The cross-sectional areas are A 1  and A 2  at nodes 1 and 2, respectively, and vary linearly. In addition, the gravitational acceleration is applied along the axial directi ...

1 what are the values of the radiation resistance and the

1. What are the values of the radiation resistance and the directivity for a half-wave dipole? 2. What is an antenna array? 3. Justify the approximations involved in the determination of the resultant field of an array o ...

Each round in a block cipher should be invertible to make

Each round in a block cipher should be invertible to make the whole block invertible. Modern block ciphers use two approaches to achieve this. In the first approach, each component is invertible; in the second approach s ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen