Ask Question, Ask an Expert

+61-413 786 465

info@mywordsolution.com

Ask Civil Engineering Expert

Question 1

In a trapezoidal canal with base width of 25 m, bed slope of 0.000167, Manning's roughness coefficient of 0.025, side slope of 2:1 ( Horizontal: Vertical) and flow rate of 60m3/s:

a) determine normal depth

b) determine critical depth

c) what are Froude number and flow regime?

Question 2

Water flows uniformly at a depth y1= 40 cm in the concrete channel, which is 10 m wide. (Figure Q2). Estimate the height of the hydraulic jump that will form when a sill is installed to force it to form.( Do not take the channel as a wide canal, make reasonable assumption of required data)

2014_Estimate the height of the hydraulic jump.png

Question 3

Find flow speed and depth of water above a hump in the Figure Q3. Calculate critical depth, Froude number and draw specific energy curve. If raise hump by 0.07 how depth of water changes upstream.

892_Estimate the height of the hydraulic jump1.png

Question 4

A floodway is designed to carry 25 m3/s of flow across a rural road. If ground slope is 0.002 and roughness coefficient 0.035, calculate width and velocity of water for wading up to the knee height. Is this floodway safe to wade? Why?

Question 5

A wide canal has a bed slope of 0.001 and carries water at a normal depth of 1.2 m. A weir is to be constructed at one point to increase the depth of flow to 2.4m.

a) How far upstream of the weir will the depth be 1.35 m? Take Manning roughness coefficient as 0.018. What is the water surface profile and why?

b) Instead of the weir a free overfall is constructed. Where upstream of the free overfall 98% of the normal depth occurs? What is the water surface profile and why?

c) In case of (b) where the EXACT normal depth occurs?

Question 6

Sketch possible water surface profiles for the channel in the Figure Q6, a, b and c. First locate and mark control points, then sketch the profiles, marking each profile with the appropriate designation. Show any hydraulic jumps that occur.

485_Estimate the height of the hydraulic jump2.png

---------------------------------------------------------------------------------------

Solution file contains the complete solution for this order including all six problems and sub-parts. The solution file contains the format of PDF and all questions are answered in sequences. 

Civil Engineering, Engineering

  • Category:- Civil Engineering
  • Reference No.:- M91270991
  • Price:- $90

Priced at Now at $90, Verified Solution

Have any Question?


Related Questions in Civil Engineering

Assessment taskpractical investigationinstructions- it is

Assessment Task Practical Investigation Instructions: - It is very important that you read these instructions. - The hardcopy of the Assignment report, with the Assignment cover sheet, should be submitted to the Assignme ...

1 aimthe assignment aims to develop the ability to analyse

1. Aim The assignment aims to develop the ability to analyse, evaluate, research plan and manage a major building project through individual and group participation (ideally 4-6 people).Refer to vUWS for the DA plans and ...

The drainage system of a cantilever wall shown in below

The drainage system of a cantilever wall shown in below figure, became blocked after a heavy rainstorm and the groundwater level, which was originallybelow the base, rose to1.5 (m) below the surface. Determine the stabil ...

Task details the client is doing masters in civil

Task Details: The client is doing Masters in Civil Engineering. He needs a Technical Paper on Earthquake pertaining to Geology and Rock Mechanics. There should be a through discussion of Earthquake in relation to the men ...

Civilyou are provided with bill of quantities prepared

Civil You are provided with bill of quantities prepared separately, priced and submitted by 3 con- tractors (A,B,C found on LMS) in respect of a proposed project (see appendix for drawings). The site is located on Mt. Al ...

Assignment -ewb design report format - cover page - the as

Assignment - EWB Design Report Format - Cover page - The as EWB project Table of content Introduction about -EWB and CRDT (Cambodian Rural development team) Background about Cambodia - Economic, Weather, People - living ...

Assignmenta continuous three spans beam with

Assignment A continuous three spans beam with centre-to-centre distance of 6 m supports 150 mm thick one-way slabs as shown below. The beams have clear spans of 8 m, 9 m, and 8 (face-to-face of 400 mm square columns). Th ...

Masonry design assignmentquestion 1 - derivation of seismic

MASONRY DESIGN ASSIGNMENT Question 1 - Derivation of seismic actions on building a) Determine the storey seismic weights (Wi) for each suspended level of the building, hence the seismic weight (Wt) of the entire building ...

Masonry design assignmentquestion 1 - derivation of seismic

MASONRY DESIGN ASSIGNMENT Question 1 - Derivation of seismic actions on building a) Determine the storey seismic weights (Wi) for each suspended level of the building, hence the seismic weight (Wt) of the entire building ...

Aimthis assignment aims to demonstrate the structural

Aim: This assignment aims to demonstrate the structural design requirements of a glazed façade in a multi-storey building. Among other requirements, the glazed façade is required to comply with Australian Standard AS 204 ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As