Ask Electrical & Electronics Expert

Question 1. Multipath occurs in a radio channel creating small-scale fading due to the following factor:
Rapid changes in signal strength
Random frequency modulation
Time dispersion
All of the above
None of the above

Question 2. Wavelength is ________________ proportional to frequency.
directly
inversely
not
equally

Question 3. A vehicle is traveling at 25 m/s directly toward the transmitter while receiving a mobile signal at 1900 MHz. What is the received frequency?
1900.00158 MHz
1900 MHz
1899.99842 MHz
1900.000158 MHz
None of the above

Question 4. The coherence bandwidth of a communication channel is estimated to be 2 kHz. Small scale propagation measurements are made in real time from a vehicle moving at 70 m/s. Assuming that samples are taken at intervals of 1/4 the Coherence time to ensure correlation of consecutive samples, how many samples are taken over a 20 m travel distance?
1600
800
3200
2400
None of the above

Question 5. Multipath occurs in a radio channel creating small-scale fading due to the following factor:
Rapid changes in signal strength
Random frequency modulation
Time dispersion
All of the above
None of the above

Question 6. Wavelength is ________________ proportional to frequency.
directly
inversely
not
equally

Question 7. A vehicle is traveling at 25 m/s directly toward the transmitter while receiving a mobile signal at 1900 MHz. What is the received frequency?
1900.00158 MHz
1900 MHz
1899.99842 MHz
1900.000158 MHz
None of the above

Question 8. The coherence bandwidth of a communication channel is estimated to be 2 kHz. Small scale propagation measurements are made in real time from a vehicle moving at 70 m/s. Assuming that samples are taken at intervals of 1/4 the Coherence time to ensure correlation of consecutive samples, how many samples are taken over a 20 m travel distance?
1600
800
3200
2400
None of the above

Question 9. Assume a discrete channel impulse response is used to model an urban RF radio channel with excess delays as large as 125 µs. If the number of multipath bins is fixed at 64, what is the maximum RF bandwidth which the model can accurately represent?
2.048 MHz
1.024 MHz
4.096 MHz
512 kHz
None of the above

Question 10. A spread spectrum system using sliding correlation has the following properties: Chip Rate = 32 Mbps; Slide factor 10-4; 24 shift registers in the sequence generator. What is the time between maximum correlations (ΔT)?
68.3 µs
57.6 µs
25.4 µs
46.5 µs
None of the above

Question 11. In small scale fading based on Doppler spread, fast fading has the characteristics of:
Low Doppler spread
Coherence time less than symbol period
Channel variations slower than baseband signal variations
Both b and c
None of the above

Question 12. _________________ diversity can be created without using additional bandwidth.
Frequency
Time
Spatial
all of the above
None of the above

Question 13. A certain transmission channel has a bandwidth of 2 MHz. What is the channel capacity if the SNR is 37 dB?
12.3 Mbps
18.6 Mbps
24.58 Mbps
36.3 Mbps
None of the above

Question 14. Multiple input, multiple output (MIMO) diversity gains can be obtained with the following:
multiple receive antennas
multiple transmit antennas
both a and b
neither a nor b

Question 15. What is the bandwidth of a raised cosine filter pulse with a symbol time of 64 µs and a roll-off factor of 0.25?

19.5 kHz
80 MHz
26.4 kHz
19.5 MHz
None of the above

Question 16. Linear predictive coders (LPC) belong to the ____________ domain class of vocoders.
frequency
spatial
hybrid
time
None of the above

Question 17. A frequency hopping spread spectrum system has a spread spectrum bandwidth of 2.1 MHz and each hop bandwidth is 7 kHz. How many frequency hop slots are there in this system?
21
15
250
300
None of the above

Question 18. What is the processing gain (in dB) of a spread spectrum system that has system bandwidth of 400 MHz and an information bandwidth of 200 KHz?

33 dB
27 dB
-33 dB
-27 dB
None of the above

Question 19. PN sequences in a spread spectrum communication system ______________ repeat after the period of the sequence is generated.
never
occasionally
always
annually

Question 20. A correlation function equals _______________ if the two codes have nothing in common.
one
64
zero
None of the above

Question 21. Frequency division duplexing (FDD) provides __________ distinct bands of frequencies for every user.
One
Three
Five
Seven
None of the above

Question 22. A TDMA system has a 25 MHz bandwidth with single channels of 250 kHz bandwidth each, with each frequency channel containing eight TDMA conversation channels. If each user is assigned one transmit and one receive slot within each frequency channel, calculate the number of users this system can support. Assume there is no separate guard band.
100
800
400
200
None of the above

Question 23. A system has eight trailing bits, eight guard bits, 32 synchronizing bits, and three traffic bursts of 64 bits of data per time slot. What is the frame efficiency if there are eight time slots per bit frame?
20%
40%
60%
80%
None of the above

Question 24. In a cellular system, channels are reused within _________________.
same cell
same cluster
coverage area
Never

Question 25. One of the differences between 2G Mobile Radio Networks and 2.5G Mobile Radio Networks is:

Internet browsing is not supported in 2G systems
Different transmit frequencies are used
Different multiple access technologies are used
All of the above
None of the above

Question 26. CDMA systems increase a user's data throughput by _____________________
assigning more frequencies
increasing spatial separation between users
increasing the length of a PN code
allowing the use of multiple Walsh codes
None of the above.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M92182852
  • Price:- $25

Priced at Now at $25, Verified Solution

Have any Question?


Related Questions in Electrical & Electronics

Question 1for the ce amplifier in figure 1 given the

Question 1 For the CE amplifier in Figure (1), given the following component parameters: Parameter Value β DC , β AC 150 V BE 0 . 7 V V CC 12 V R C 820 ? R E 1 100 ? R E 2 220 ? R 1 20 k? R 2 5 . 2 k? R L 100 k? C 1 , C ...

Question -i a star-connected three-phase synchronous

Question - (i) A star-connected, three-phase synchronous induction motor takes a current of 10 amps from a 415 volt supply at unity power factor when supplying a steady load. If the synchronous reactance is 5 ohms/phase ...

1 a name the three major groups of contamination and

1. (a) Name the three major groups of contamination and briefly describe their physical characteristics. (b) Where do the above contamination types come from? Give one example of each. 2. Name two processes metrics which ...

Question 1 in the voltage regulator circuit in figure p221

Question 1: In the voltage regulator circuit in Figure P2.21, V 1 = 20 V, V Z = 10 V, R i = 222Ω and P z (max) = 400 mW. (a) Determine I L, I z , and I L , if R L = 380Ω. (b) Determine the value of R L , that will establ ...

Summative assessmentin 2017 sej101 assessment will consist

Summative Assessment In 2017 SEJ101 assessment will consist of nine tasks that will develop a portfolio of your assessed work. Throughout the trimester you will have the opportunity for feedback on all nine tasks before ...

1 a name the three major groups of contamination and

1. (a) Name the three major groups of contamination and briefly describe their physical characteristics. (b) Where do the above contamination types come from? Give one example of each. 2. Name two processes metrics which ...

1 a name the three major groups of contamination and

1. (a) Name the three major groups of contamination and briefly describe their physical characteristics. (b) Where do the above contamination types come from? Give one example of each. 2. Name two processes metrics which ...

Case studythis assignment consists of a written report of

CASE STUDY This assignment consists of a written report of approximately 1000 words and any diagrams in which you are asked to critically compare different process methods used to achieve the same result and show an awar ...

Problem 1 a two-phase servomotor has rated voltage applied

Problem 1: A two-phase servomotor has rated voltage applied to its excitation winding. The torque speed characteristic of the motor with Vc = 220 V, 60 Hz applied to its control phase winding is shown in Fig.1. The momen ...

Electrical engineering questions -q1 two ideal voltage

Electrical Engineering Questions - Q1. Two ideal voltage sources designated as machines 1 and 2 are connected, as shown in the figure below. Given E 1 = 65∠0 o V, E 2 = 65∠30 o V, Z = 3Ω. Determine if Machine 1 is genera ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As