Ask Electrical & Electronics Expert

Quantum Devices-

1. Explain why "giant magnetoresistance" is considered a quantum mechanical phenomena and why it may be classified as "spintronics". What is its major application? This will require a bit of research on your part. Make sure you list references you used to formulate your answer. DO NOT simply quote Wikipedia!! This will get you few points.

2. In the conclusions of the paper by Sun et. al., it says:

"In view of applications, our view is that two-terminal devices such as wires, rectifiers and multivalued logic single-molecule devices can be expected to emerge as the most feasible route towards molecular devices." (pg 7403, 3rd full paragraph).

Based on the information that the authors present in their paper, why do you believe this is their view? Support your answer with at least three quotes from the content of the paper. Give the page and paragraph number like I did above.

3. In the paper by Avouris et. al., a carbon nanotube device is described in Figure 18, where the Vin vs. Vout characteristic is shown (an enlarged copy is attached). In the paper by Stan et. al., one of the reasons digital electronics is so useful is the ability to "reject noise" (Section IV, Part A, pg. 1946).

a. For the device in the Avouris paper, if Vout is saturated at its largest positive value, what is the minimum change in Vin () that would cause the inverter to switch so that Vout is negative? Show on the figure how you arrived at your number.

b. What percentage is this voltage change () of the total possible voltage swing of Vout (voltage range from highest to lowest voltage). Show on the attached figure how you arrived at and the total voltage swing for Vout.

c. According to the criteria that Stan et. al. quotes as needed "noise rejection" for digital electronics (make sure you identify this criteria in your solution), does the carbon nanotube device associated with this figure meet the criteria? Explain.

4. What will be the ultimate factor that decides what, if any, quantum electronics technology succeeds MIS technology sometime in the future?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M91785811

Have any Question?


Related Questions in Electrical & Electronics

Question 1for the ce amplifier in figure 1 given the

Question 1 For the CE amplifier in Figure (1), given the following component parameters: Parameter Value β DC , β AC 150 V BE 0 . 7 V V CC 12 V R C 820 ? R E 1 100 ? R E 2 220 ? R 1 20 k? R 2 5 . 2 k? R L 100 k? C 1 , C ...

Question -i a star-connected three-phase synchronous

Question - (i) A star-connected, three-phase synchronous induction motor takes a current of 10 amps from a 415 volt supply at unity power factor when supplying a steady load. If the synchronous reactance is 5 ohms/phase ...

1 a name the three major groups of contamination and

1. (a) Name the three major groups of contamination and briefly describe their physical characteristics. (b) Where do the above contamination types come from? Give one example of each. 2. Name two processes metrics which ...

Question 1 in the voltage regulator circuit in figure p221

Question 1: In the voltage regulator circuit in Figure P2.21, V 1 = 20 V, V Z = 10 V, R i = 222Ω and P z (max) = 400 mW. (a) Determine I L, I z , and I L , if R L = 380Ω. (b) Determine the value of R L , that will establ ...

Summative assessmentin 2017 sej101 assessment will consist

Summative Assessment In 2017 SEJ101 assessment will consist of nine tasks that will develop a portfolio of your assessed work. Throughout the trimester you will have the opportunity for feedback on all nine tasks before ...

1 a name the three major groups of contamination and

1. (a) Name the three major groups of contamination and briefly describe their physical characteristics. (b) Where do the above contamination types come from? Give one example of each. 2. Name two processes metrics which ...

1 a name the three major groups of contamination and

1. (a) Name the three major groups of contamination and briefly describe their physical characteristics. (b) Where do the above contamination types come from? Give one example of each. 2. Name two processes metrics which ...

Case studythis assignment consists of a written report of

CASE STUDY This assignment consists of a written report of approximately 1000 words and any diagrams in which you are asked to critically compare different process methods used to achieve the same result and show an awar ...

Problem 1 a two-phase servomotor has rated voltage applied

Problem 1: A two-phase servomotor has rated voltage applied to its excitation winding. The torque speed characteristic of the motor with Vc = 220 V, 60 Hz applied to its control phase winding is shown in Fig.1. The momen ...

Electrical engineering questions -q1 two ideal voltage

Electrical Engineering Questions - Q1. Two ideal voltage sources designated as machines 1 and 2 are connected, as shown in the figure below. Given E 1 = 65∠0 o V, E 2 = 65∠30 o V, Z = 3Ω. Determine if Machine 1 is genera ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As