Ask Question, Ask an Expert

+61-413 786 465

info@mywordsolution.com

Ask Civil Engineering Expert

Q. Which type of pile cap transfers loads equally to piles, flexible pile cap orrigid pile cap?

Loads from columns transferring to pile cap persuade tensile forces at the bottom of the cap. For example by using truss analogy to analyse a pile cap sitting on two piles with a column at the centre of pile cap, tensile force at the bottom is proportional to pile spacing and is inversely proportional to depth of pile cap. Bottom reinforcement is designed to resist tensile stressed produced from loads in columns. Occasionally reinforcement can be designed at the top of pile caps that serve as compression reinforcement. This kind of reinforcement is essential in case there is a limitation on the depth of pile caps. In the same way shear reinforcement is introduced to the pile caps in case there is a restriction to the depth of pile caps. 

Consider that loads are applied at the centre of a pile cap.

For the case of rigid pile cap, due to the effect of interaction of individual piles, central piles tend to settle more than edge piles when pile cap is under loading condition. For the pile cap to be rigid, local deformation of central piles wouldn't take place. In its placestiff pile cap would transfer the loads from central piles and redistribute them to outer piles. So piles at the edge take up a higher fraction of total loads and are subjected to higher axial and bending loads in case the pile cap is stiff. In the extreme case, side piles may take up as much as about two to three times loads in the central piles and this may lead to failure of these edge piles. 

For flexible pile cap, load taken up by individual piles are different since the deformation of pile cap enhances non-uniform distribution of loads among piles. Piles closer to the load tend to share more loads when compared with those that are located far away from the loads. The difference of loads persuaded in piles increase with flexibility of pile cap.

Civil Engineering, Engineering

  • Category:- Civil Engineering
  • Reference No.:- M9576199

Have any Question?


Related Questions in Civil Engineering

Task details the client is doing masters in civil

Task Details: The client is doing Masters in Civil Engineering. He needs a Technical Paper on Earthquake pertaining to Geology and Rock Mechanics. There should be a through discussion of Earthquake in relation to the men ...

Assessment taskpractical investigationinstructions- it is

Assessment Task Practical Investigation Instructions: - It is very important that you read these instructions. - The hardcopy of the Assignment report, with the Assignment cover sheet, should be submitted to the Assignme ...

The drainage system of a cantilever wall shown in below

The drainage system of a cantilever wall shown in below figure, became blocked after a heavy rainstorm and the groundwater level, which was originallybelow the base, rose to1.5 (m) below the surface. Determine the stabil ...

Masonry design assignmentquestion 1 - derivation of seismic

MASONRY DESIGN ASSIGNMENT Question 1 - Derivation of seismic actions on building a) Determine the storey seismic weights (Wi) for each suspended level of the building, hence the seismic weight (Wt) of the entire building ...

Assignmenta continuous three spans beam with

Assignment A continuous three spans beam with centre-to-centre distance of 6 m supports 150 mm thick one-way slabs as shown below. The beams have clear spans of 8 m, 9 m, and 8 (face-to-face of 400 mm square columns). Th ...

Civilyou are provided with bill of quantities prepared

Civil You are provided with bill of quantities prepared separately, priced and submitted by 3 con- tractors (A,B,C found on LMS) in respect of a proposed project (see appendix for drawings). The site is located on Mt. Al ...

Aimthis assignment aims to demonstrate the structural

Aim: This assignment aims to demonstrate the structural design requirements of a glazed façade in a multi-storey building. Among other requirements, the glazed façade is required to comply with Australian Standard AS 204 ...

Masonry design assignmentquestion 1 - derivation of seismic

MASONRY DESIGN ASSIGNMENT Question 1 - Derivation of seismic actions on building a) Determine the storey seismic weights (Wi) for each suspended level of the building, hence the seismic weight (Wt) of the entire building ...

Aimthis assignment aims to demonstrate the structural

Aim: This assignment aims to demonstrate the structural design requirements of a glazed façade in a multi-storey building. Among other requirements, the glazed façade is required to comply with Australian Standard AS 204 ...

Assignment -ewb design report format - cover page - the as

Assignment - EWB Design Report Format - Cover page - The as EWB project Table of content Introduction about -EWB and CRDT (Cambodian Rural development team) Background about Cambodia - Economic, Weather, People - living ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As