Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe the term magic tee in detail.

2) Design the constructional diagram of the two cavity klystron amplifier.

3) Describe the working principle of hybrid tee with the help of neat diagram.

4) describe the term multi-cavity klystron that is used as an amplifier with the apple gate diagram.

5) Discuss the constructional and working principle of Travelling Wave Tube or TWT.

6) Describe the function of following given microwave components:

a) Isolator

b) Circulator

7) describe the term Doppler Effect and how it is used for measuring the speed?

8) describe MTI Radar with the help of diagram.

9) Provide the radar range equation and describe various factors that are influencing the range of radar.

10) describe the concept of Doppler Effect.

11) describe the various types of Antenna Scanning Techniques in the Radar?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911979

Have any Question? 


Related Questions in Electrical & Electronics

Consider two bar elements under a force at the tip using

Consider two bar elements under a force at the tip. Using the displacement controlled method, plot the load-displacement curve (F vs. u 2  and u 3 ). Increase the tip displacement u 3  up to 1.0 m by ten equal increments ...

1 draw the symbols for the nand nor xor and xnor gates what

1. Draw the symbols for the NAND, NOR, XOR, and XNOR gates. What is the difference between the Buffer, AND, OR, XOR and the NOT, NAND, NOR, and XNOR gates? 2. Modify the circuit from question 2 to use a second AND gate o ...

1 energy calculationsbuilding sf 20000 sfelectric rateuse

1. Energy Calculations Building SF = 20,000 sf Electric Rate: Use MTSU Utility Rate Schedule - Seasonal Rates Lighting: 2 watts/sf hours of operation = 19 hours per day Motors: One water pump motor, 80% efficient, runnin ...

1 what is snells law2 what is meant by the plane of

1. What is Snell's law? 2. What is meant by the plane of incidence? Distinguish between the two different linear polarizations pertinent to the derivation of the reflection and transmission coefficients for oblique incid ...

An exhaust stream leaving a semiconductor fabrication plant

An exhaust stream leaving a semiconductor fabrication plant contains 4 mol % volatile organic chemical, VOC, pollutant. Twenty-five cubic meters per minute enter the bottom of a packed absorption tower and flows counterc ...

A a signal x t 5 sinc2 5pit cos 20pit is sampled at a

a. A signal x (t) = 5 sinc 2 (5πt) + cos 20πt is sampled at a rate of 10 Hz. Find the spectrum of the sampled signal. Can x (t) be reconstructed by lowpass filtering the sampled signal? b. Repeat part (a) for a sampling ...

1 is it meaningful to consider two different surfaces

1. Is it meaningful to consider two different surfaces bounded by a closed path to computethe two different currents on the right side of Ampere's circuital law to find around the closed path? 2. Discuss briefly the appl ...

Power mosfet breakdown voltage 800v must conduct 10a when

power mosfet breakdown voltage 800v must conduct 10A when on with a maximum on state voltage 4v.If the current density in the mosfet must be limited to 200A/cm,estimate the conduxting area

1 in jpeg explain why we need to round the result of

1. In JPEG, explain why we need to round the result of division in the quantization step. 2. Explain why the combination of quantization/dequantization steps in JPEG is a lossy process even though we divide each element ...

Objectivesthe objectives of this experiment are1 to

OBJECTIVES: The objectives of this experiment are: 1) To investigate the operation of automatic reset circuits. 2) To understand the difference between a positive edge triggered, negative edge triggered, and a level trig ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro