Ask Question, Ask an Expert

+61-413 786 465

info@mywordsolution.com

Ask Mechanical Engineering Expert

Problem 1. Consider 100 m^3 of moist air at 100 kPa , 45 C and 80 % , R.H.

Part A

Calculate the humidity ratio (ω).

Express the answer in kilograms of water per kilograms of dry air to four significant figures.

Part B

Calculate the dew point.

Express your answer in degrees Celsius to four significant figures.

Part C

Calculate the mass of vapor.

Express your answer to three significant figures using appropriate units.

Part D

What-if scenario: What would the dew point be if the moist air was at 60 % R.H.?
Express your answer in degrees Celsius to four significant figures.

Problem 2. A room contains air at 10 °C and 95 kPa with a relative humidity of 80 %

Part A

Determine the partial pressure of dry air.

Express your answer to four significant figures using the appropriate units.

Part B

Determine the specific humidity (ω) of the air.
Express your answer in kilograms of water vapor per kilograms of dry air to four significant figures.

Part C

Determine the enthalpy per unit mass of dry air.
Express your answer in kiljoules per kilograms of dry air to four significant figures.

Part D

What-if scenario: Determine the partial pressure of dry air if the pressure is 85 kPa.
Express your answer to four significant figures using the appropriate units.

Part E

What-if scenario: Determine the specific humidity (ω) of the air if the pressure is 85 kPa.
Express your answer in kilograms of water vapor per kilograms of dry air to four significant figures.

Part F

What-if scenario: Determine the enthalpy per unit mass of dry air if the pressure is 85 kPa.
Express your answer in kiljoules per kilograms of dry air to four significant figures.

Problem 3. A tank with a volume 20 m3 contains a mixture of carbon dioxide and water vapor at 18 °C and 100 kPa with a relative humidity (?) of 80 % .

Part A

Determine the partial pressure of dry CO2.
Express your answer to four significant figures using the appropriate units.

Part B

Determine the specific humidity (ω) of the mixture.
Express your answer in kilograms of water per kilograms of carbon dioxide to four significant figures.

Part C

Determine the dew point.
Express your answer in degrees Celsius to four significant figures.

Part D

Determine the amount of vapor.
Express your answer to four significant figures using the appropriate units.

Part E

Determine the mass of CO2.
Express your answer to four significant figures using the appropriate units.

Part F

What-if scenario: What would the amount of vapor be if the mixture was composed of dry air and water vapor?
Express your answer to four significant figures using the appropriate units.

Problem 3. A 10 m3 tank contains saturated air at 40 °C, 101 kPa .

Part A
Determine the specific humidity (ω).
Express your answer in kilograms of water per kilograms of dry air to four significant figures.

Part B
Determine the mass of dry air.
Express your answer to four significant figures using the appropriate units.

Part C
Determine the enthalpy of the dry air, per unit mass of the dry air.
Express your answer in kilojoules per kilograms of dry air to four significant figures.

Problem 4. Air in a room has a dry-bulb temperature of 24 °C and a wet-bulb temperature of 18 °C. Assume a pressure of 100 kPa .

Part A
Determine the specific humidity (ω).
Express your answer to four significant figures.

Part B
Determine the relative humidity (?).
Express your answer to four significant figures.

Part C
Determine the dew-point temperature.
Express your answer to four significant figures.

Part D
What-if scenario: What would the relative humidity be if the wet-bulb temperature was 15°C?
Express your answer to four significant figures.

Problem 5. Air in a room is at 1 atm , 22 °C and 55 % percent relative humidity (?).

Part A
Determine the specific humidity (ω) of the air.
Express your answer in kilograms of water per kilograms of dry air to four significant figures.

Part B
Determine the enthalpy (h) of the air.
Express your answer in kilojoules per kilograms of dry air to four significant figures.

Part C
Determine the wet-bulb temperature of the air.
Express your answer in degrees Celsius to four significant figures.

Part D
Determine the dew-point temperature of the air.
Express your answer in degrees Celsius to four significant figures.

Part E
Determine the specific volume (v) of the air.
Express your answer in cubic meters per kilograms of dry air to four significant figures.

Problem 6. Air in a room has a pressure of 1 atm , a dry-bulb temperature of 26 °C, and a wet-bulb temperature of 16 °C.

Part A

Determine the specific humidity (ω) of the air.
Express your answer in kilograms of water per kilograms of dry air to four significant figures.

Part B

Determine the enthalpy (h) of the air.
Express your answer in kilojoules per kilograms of dry air to four significant figures.

Part C
Determine the relative humidity (?) of the air.
Express your answer in percent to four significant figures.

Part D
Determine the dew-point temperature of the air.
Express your answer in degrees Celsisu to four significant figures.

Part E
Determine the specific volume (v) of the air.
Express your answer in cubic meters per kilograms of dry air to four significant figures.

Mechanical Engineering, Engineering

  • Category:- Mechanical Engineering
  • Reference No.:- M92016734

Have any Question?


Related Questions in Mechanical Engineering

Fluid mechanics assignment - finite control volume analysis

Fluid Mechanics Assignment - Finite Control Volume Analysis and Dimensional Analysis Q1. The wind blows through a 7ft × 10ft garage door opening with a speed of 5 ft/s as shown in the figure. Determine the average speed, ...

Alocate ten minutes for the presentationuse audio visual

Allocate ten minutes for the presentation Use audio / visual / technological supports / aids where appropriate Use a minimum of 3 properly referenced articles. THEMES PRESENTATION TOPIC MEMORY Discuss the three learning ...

Materials behaviour from atoms to bridges assignment -

Materials Behaviour from Atoms to Bridges Assignment - Distributed loads and static equilibrium (Please note: you should show your steps with necessary figures) Q1. Two beam sections are jointed at C and supported at A b ...

Fluid mechanics assignment - viscous flow in pipesq1 as

Fluid Mechanics Assignment - Viscous Flow in Pipes Q1. As shown in the figure below, water "bubbles up" 3 in. above the exit of the vertical pipe attached to three horizontal pipe segments. The total length of the 0.75-i ...

Force exerted by jet on moving cart1 you need to determine

Force Exerted By Jet On Moving cart. 1. You need to determine the velocity of water that comes out from the nozzle of this system. need the equation please formulate the equation. 2. This water will strike a small cart a ...

Mechanical engineering assignment task - solve the given

Mechanical Engineering Assignment Task - Solve the given problem. Task 1 - A spring with a one-turn loop of 40mm mean radius is formed from a round section of wire having 5 mm diameter. The straight tangential legs of th ...

Life cycle assessmentfor your chosen service eg white

LIFE CYCLE ASSESSMENT For your chosen service (e.g. white board markers), identify two alternatives of getting the service (e.g. brand A, brand B). Choose the most environmentally friendly option by conducting life cycle ...

Assignment -q1 explain the difference between the

Assignment - Q1. Explain the difference between the metacentric height of a ship during 'Partially Afloat condition and 'Free Floating' condition; aid a sketch to support your answer. Q2. With the aid of sketches, explai ...

The aim of the project is to demonstrate certain aspects of

The aim of the project is to demonstrate certain aspects of engineering materials in different applications. The projects will be assessed on the basis of a written Research Report. The report should clearly show what yo ...

Question - truss structureconsider the three membered

Question - Truss Structure Consider the three membered planar truss structure shown in the figure below. All members of the truss have identical square cross-sectional area (A) of 25 mm x 25 mm, and Youngs Modulus (E) = ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As