Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1: Ordinary low frequency circuit analysis is not sufficient to describe the electrical phenomenon-taking place at microwave frequencies, describe why?

problem 2: Describe the problem of transit time effect in tubes at microwave frequencies?

problem 3: Why are semiconductors favored over the vacuum tubes in most of the applications?

problem 4: Derive an expression for the maximum possible theoretical efficiency of a two cavity klystron.

problem 5: Describe the importance of Hull voltage in the magnetron.

problem 6: Describe the principle of working of travelling wave tube.

problem 7: Determine the expression for effectiveness of two cavity Klystron amplifier.

problem 8: Describe with neat diagrams the given in a Magnetron:

a) Resonant Modes and their separation
b) Method of Oscillation.

problem 9: What do you mean by the term current modulation?

problem 10: In what kind of applications reflex klystrons is favored and describe why?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M97467

Have any Question? 


Related Questions in Electrical & Electronics

1 what is a uniform plane wave2 why is the study of uniform

1. What is a uniform plane wave? 2. Why is the study of uniform plane waves important? 3. How is the surface current density vector defined? Distinguish it from the volume current density vector. 4. How do you find the c ...

1 in polar coordinates show that2 determine the fluid

1. In polar coordinates, show that 2. Determine the fluid rotation at a point in polar coordinates, using the method illustrated in given figure.

An ltic system impulse response is given by ht ut-ut - 1a

An LTIC system impulse response is given by h(t) = u(t)-u(t - 1). a. Determine the transfer function H(s). Using H(s), determine and plot the magnitude response |H(jω)|. Which type of filter most accurately describes the ...

A signal is bandlimited to 12 khz the band between 10 and

A signal is bandlimited to 12 kHz. The band between 10 and 12 kHz has been so corrupted by excessive noise that the information in this band is nonrecoverable. Determine the minimum sampling rate for this signal so that ...

1 use the additive cipher with k 10 to encrypt the

1. Use the additive cipher with k = 10 to encrypt the plaintext "book". Then decrypt the message to get the original plaintext. 2. Encrypt the message "this is an exercise" using additive cipher with key = 20. Ignore the ...

1 assume fixed-sized packets arrive at a router with a rate

1. Assume fixed-sized packets arrive at a router with a rate of three packets per second. Show how the router can use the leaky bucket algorithm to send out only two packets per second. What is the problem with this appr ...

A periodic signal xt is expressed by the following fourier

A periodic signal x(t) is expressed by the following Fourier series: a. Sketch the amplitude and phase spectra for the trigonometric series. b. By inspection of spectra in part (a), sketch the exponential Fourier series ...

1 in logisim implement an 8-to-1 mux using 2 4-to-1 muxes

1. In Logisim implement an 8-to-1 MUX using 2 4-to-1 MUXes and a 2-to-1 MUX. 2. In Logisim implement an 8-to-1 MUX using 4 2-to-1 MUXes and a 4-to-1 MUX. 3. In Logisim implement a circuit similar to the one in figure 8-1 ...

Given the message accbcaab in which the probabilities of

Given the message "ACCBCAAB*", in which the probabilities of symbols are P(A) = 0.4, P(B) = 0.3, P(C) = 0.2, and P(*) = 0.1, a. find the compressed data using arithmetic coding with a precision of 10 binary digits. b. fi ...

The trigonometric fourier series of a certain periodic

The trigonometric Fourier series of a certain periodic signal is given by a. Sketch the exponential Fourier spectra. b. By inspection of the spectra in part (a), sketch the trigonometric Fourier spectra for x(t). Find th ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen