Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) One of the sidebands of an AM (DSB-LC) broadcast station is measured to have a power of 63 dBm. If the modulation is 100%, what is the total signal power in watts?

2) The input to an ideal (rectangular) lowpass filter is x(t) = 2 sinc(0.0005t). If the low pass filter’s cutoff frequency is 5,000 Hz, what is the energy of the output signal?

3) A satellite is to receive signals on a frequency of 28.5 GHz and re-transmit them back to earth on a frequency of 12.5 GHz. Using a mixer:

a) What local oscillator frequency would you use? There are two possibilities. What is the alternate frequency?

b) For the local oscillator you selected, what transmission frequencies could cause interference to the satellite system and how could the interference be avoided? Show a diagram.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M95510

Have any Question? 


Related Questions in Electrical & Electronics

The device in the schematic diagram below is a viscosity

The device in the schematic diagram below is a viscosity pump. It consists of a rotating drum inside of a stationary case. The case and the drum are concentric. Fluid enters at A, flows through the annulus between the ca ...

In arithmetic coding assume we have received the code

In arithmetic coding, assume we have received the code 100110011. If we know that the alphabet is made of four symbols with the probabilities of P(A) = 0.4, P(B) = 0.3, P(C) = 0.2, and P(*) = 0.1, find the original messa ...

A 12-bit oversampling adc oversamples by a factor of m 64

A 12-bit oversampling ADC oversamples by a factor of M = 64. To achieve the same average power of the quantization noise at the output, but without using oversampling, how many bits are required?

Problem 1 an amplifier is observed to have an output noise

Problem 1: An amplifier is observed to have an output noise rms-voltage of 1.0 μV. If the noise bandwidth is 25 kHz, determine the noise spectral density of the amplifier. Problem 2: A piezeoresistive sensor has a therma ...

1 describe briefly your concept of a scalar field and

1. Describe briefly your concept of a scalar field and illustrate with an example. 2. Describe briefly your concept of a vector field and illustrate with an example. 3. How do you depict pictorially the gravitational fie ...

A neighborhood fuel cell power plant is to be designed fo

a neighborhood fuel cell power plant is to be designed fo an electric output of 2000kwh with liquid water product . Estimate the flow rates of hydrogen and oxygen during peak power production, assuming that 80% efficient ...

Data at a rate of 1 million pulses per second are to be

Data at a rate of 1 million pulses per second are to be transmitted over a certain communications channel. The unit step response g(t) for this channel is shown in Fig. P2.7-1. a. Can this channel transmit data at the re ...

1 is the cutoff wavelength dependent on the dielectric in

1. Is the cutoff wavelength dependent on the dielectric in the waveguide? Is the cutoff frequency dependent on the dielectric in the waveguide? 2. What is guide wavelength? 3. Provide a physical explanation for the frequ ...

An initially straight beam ab is bent into a circular arc

An initially straight beam AB is bent into a circular arc A'B' as shown in the figure. The deformation is specified as Where g(X 2 ) is a simple function of X 2 . (a) Find the deformation gradient in terms of g(X 2 ). (b ...

Write a paper to summarize a literature article for less

Write a paper to summarize a literature article for less than a page and its about a shoe taking power from piezo discussion. Article: Piezoelectric Materials Used in Underwater Acoustic Transducers by Huidong Li, Z. Dan ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen