Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1: Why TEM waves can’t be propagated in the wave-guides?

problem 2: List all the methods which are used to carry out measurement of Low, Medium and high microwave power.

problem 3: What is the main use of the coupling probes and coupling loops in wave-guides?

problem 4: Compute the ratio of cross-section of circular wave-guides to that of rectangular one of each is to have similar cut off wavelength for its dominant mode?

problem 5: What do you mean by VSWR and reflection Coefficient? Describe the measurement of low, medium and high VSWR?

problem 6: Define the term Faraday’s rotation and as well tell any device based on the faraday’s rotation.

problem 7: What do you mean by Rat-race junction?

problem 8: Describe how impedance can be measured by using the slotted line method.

problem 9: Describe the methods for measurement of low and high microwave power.

problem 10: Compare practical benefits and drawbacks of circular wave-guides with those of the rectangular wave-guides.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M97499

Have any Question? 


Related Questions in Electrical & Electronics

Identify the variables associated with given problem and

Identify the variables associated with given Problem and find the dimensionless parameters. Problem The device in the schematic diagram below is a viscosity pump. It consists of a rotating drum inside of a stationary cas ...

1 what does the word retarded in the terminology retarded

1. What does the word retarded in the terminology retarded magnetic vector potential refer to? Explain. 2. Discuss the application of the magnetic vector potential in the determination of the electromagnetic fields due t ...

1 why is it necessary to have the minus sign associated

1. Why is it necessary to have the minus sign associated with the time rate of increase of magnetic flux on the right side of Faraday's law? 2. What is electromotive force? 3. What are the different ways in which an emf ...

1 what is the permittivity of free space what are its

1. What is the permittivity of free space? What are its units? 2. Describe the electric field due to a point charge. 3. How do you find the electric field intensity due to a continuous charge distribution? 4. How is curr ...

For the following truth tablea give the dnf equation for

For the following truth table: a. Give the DNF equation for the table. b. Minimize the equation using a K-map. c. Show that the DNF is equivalent to the minimum representation using Boolean algebra.

Solve problem using force equilibrium ie internal force

Solve Problem using force equilibrium; i.e., internal force caused by stress is equal to external force. Problem A force F is applied at the tip of the uniform bar element shown in the figure. The initial length and the ...

The spacing a between the plates of a parallel-plate

The spacing a between the plates of a parallel-plate waveguide is equal to 5 cm. The dielectric between the plates is free space. If a generator of fundamental frequency 1800 MHz and rich in harmonics excites the wavegui ...

1 state amperes force law as applied to current elements2

1. State Ampere's force law as applied to current elements. 2. Why is it not necessary for Newton's third law to hold for current elements? 3. What is the permeability of free space? What are its units? 4. Describe the m ...

1 in jpeg explain why we need to round the result of

1. In JPEG, explain why we need to round the result of division in the quantization step. 2. Explain why the combination of quantization/dequantization steps in JPEG is a lossy process even though we divide each element ...

1 why is it necessary to have the displacement current term

1. Why is it necessary to have the displacement current term on the right side of Ampere's circuital law? 2.28. When can you say that the current in a wire enclosed by a closed path is uniquely defined? Give two examples ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen