Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1:

Illustrate the BCD system and also describe its advantages and disadvantages.

problem 2:

prepare down the steps which are involved to add two numbers by excess 3 – code.

problem 3:

Provide theory of propagation of light through fibre wire and analyse this with different angles of incidence.

problem 4:

Illustrate the principle behind the propagation of light through the fiber.

problem 5:

Mention the advantages of optical fiber communication over conventional communication.

problem 6:

Illustrate the formation and propagation of the magnetic bubbles in magnetic materials.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913619

Have any Question? 


Related Questions in Electrical & Electronics

Research paperwrite a research essay about zigbee for

Research Paper Write a research essay about zigbee for electrical class. The research paper should include four pages and three references.

1 explain why rtp cannot be used as a transport-layer

1. Explain why RTP cannot be used as a transport-layer protocol without being run on the top of another transport-layer protocol such as UDP. 2. Both TCP and RTP use sequence numbers. Do sequence numbers in these two pro ...

Calculate the approximate diameter and length of stator

Calculate the approximate diameter and length of stator core, the number of stator slots and the number of conductors for a 20KW,400V,3 phase,4pole,1200rpm,delta connected induction motor. Bav=0.5T, Kw=0.82, ac=26000amp. ...

1what is an electric dipole how is its strength defined2

1.What is an electric dipole? How is its strength defined? 2. What are the different kinds of polarization in a dielectric? 3. What is the polarization vector? How is it related to the electric field intensity? 4. Discus ...

1 outline the steps involved in the magnetoquasistatic

1. Outline the steps involved in the magnetoquasistatic field analysis of a parallel plate structure and the determination of its input behavior. Compare the input behavior with the magnetostatic case. 2. Outline the ste ...

If the hertzian dipole in figure 919 is situated at a

If the Hertzian dipole in Figure 9.19 is situated at a distance from the corner and equidistant from the two planes, find the ratio of the radiation field at a point broadside to the dipole and away from the corner to th ...

1 what is an anisotropic dielectric material2 when can an

1. What is an anisotropic dielectric material? 2. When can an effective permittivity be defined for an anisotropic dielectric material? 3. Briefly describe the phenomenon of magnetization. 4. What is a magnetic dipole? H ...

1 discuss the concept of unit and group patterns and their

1. Discuss the concept of unit and group patterns and their multiplication to obtain the resultant pattern of an array. 2. Distinguish between broadside and endfire radiation patterns. 3. Discuss the concept of an image ...

1 when is it meaningful to attribute a group velocity to a

1. When is it meaningful to attribute a group velocity to a signal comprised of more than two frequencies? Why? 2. Discuss the propagation of a narrow-band amplitude modulated signal in a dispersive channel. 3. Discuss t ...

Figure 3012 shows a router using fifo queuing at the input

Figure 30.12 shows a router using FIFO queuing at the input port. The arrival and required service times for seven packets are shown below; ti means that the packet has arrived or departed i ms after a reference time. Th ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro