Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1) Why LASER is favoured over LED? How the Line-width of LASER diode play the significant role in minimizing the dispersion effect?

problem 2) What do you mean by SOA and various kinds of SOA amplifiers? Describe in detail. Compare the performance of TWA- and FPA- amplifiers.

problem 3) What are the various kinds of non-linear affects in optical communication systems? How Four Wave Mixing affects performance of the optical transmission system and describe various techniques used to reduce the Four Wave Mixing.

problem 4) Describe Pre compensation and post compensation dispersion management techniques used in optical communication system.

problem 5) How a Soliton pulse is generated? Describe in detail. How a loss managed and high speed-Soliton systems are carried out?

problem 6) Sketch a block diagram of optical receiver and discuss the Noise Mechanism in Optical Receiver? Compare the performance of P-i-N-and Avalanche- photo-detectors.

problem 7) prepare down the difference between WDM and DWDM optical communication system? Describe the chirping and significance of Chirp Parameter in reducing the dispersion in SMF fiber?

problem 8)(a) How Fiber Bragg Grating helps in reducing dispersion effects in optical communication system?

(b) A SMF fiber is measured to have λ2(d2/d λ2) = 0.02 at 800nm. Compute the dispersion parameters D and β2.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M99586

Have any Question? 


Related Questions in Electrical & Electronics

An engineering department chair is interested in comparing

An engineering department chair is interested in comparing the effect on the student grades of a well-established postgraduate module delivered using a traditional lecture mode and new distance-learning software. Fifty s ...

Develop a testbench model to verify operation of the

Develop a testbench model to verify operation of the debouncer described in Example 4.20. Example 4.20 Develop a Verilog model of a debouncer for a pushbutton switch that uses a debounce interval of 10ms. Assume the syst ...

Five resistors are in series with a 20 v source the voltage

Five resistors are in series with a 20 V source. The voltage drops across four of the resistors are 1.5 V, 5.5 V, 3 V, and 6 V. How much voltage is dropped across the fifth resistor?

Three 20-kva 24000277-v distribution transformers are

Three 20-kVA 24,000/277-V distribution transformers are connected in D-Y. The open-circuit test was performed on the low-voltage side of this transformer bank, and the following data were recorded: (a) Find the per-unit ...

Find the voltage v for the elements of given figure using

Find the voltage v for the elements of given figure using complex algebra. Sketch the waveforms of v and i on the same sewt of axes.

The circuit shown in figure p1534 exhibits low-pass

The circuit shown in Figure P15.34 exhibits low-pass, high-pass, and band-pass voltage gain characteristics, depending on whether the output is taken at node 1, node 2, or node 3. Find the transfer functions relating eac ...

Repeat given problem for the network of given figure

Repeat given problem for the network of given figure a. Problem Using the dual of Millman's theorem, find the current through and voltage across the resistor R L  of given figure b.

Consider a four-pole feedback system with a loop gain given

Consider a four-pole feedback system with a loop gain given by Determine the value of β that produces a phase margin of 45 degrees.

A how can the sequence of spectra in illustration 86 be

(a) How can the sequence of spectra in Illustration 86 be explained by means of the Symmetry Principle SP? (b) Draw a symmetrical spectrum for the two bottom spectra.

For the network of given figure determine the following 100

For the network of given figure, determine the following 100 ms after the switch is closed: a. V ab b. V ac c. V cb d. V da e. If the switch is moved to position 2 one hour later, find the time required for v R2  to drop ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

A cola-dispensing machine is set to dispense 9 ounces of

A cola-dispensing machine is set to dispense 9 ounces of cola per cup, with a standard deviation of 1.0 ounce. The manuf

What is marketingbullwhat is marketing think back to your

What is Marketing? • "What is marketing"? Think back to your impressions before you started this class versus how you

Question -your client david smith runs a small it

QUESTION - Your client, David Smith runs a small IT consulting business specialising in computer software and techno

Inspection of a random sample of 22 aircraft showed that 15

Inspection of a random sample of 22 aircraft showed that 15 needed repairs to fix a wiring problem that might compromise

Effective hrmquestionhow can an effective hrm system help

Effective HRM Question How can an effective HRM system help facilitate the achievement of an organization's strate