Ask Question, Ask an Expert

+61-413 786 465

info@mywordsolution.com

Ask Mechanical Engineering Expert

Fundamental principles and constitutive relations

Problem 1.) Shortly after you light a candle, the flame reaches the melting temperature (To). It has an initial length of Lo that will decrease while melting. There is a net heat flux qo to the top surface of the candle and convective heat transfer to the atmosphere (T∞ with heat coefficient h) from the side.

Derive the governing equations and state the boundary conditions to determine Temperature profile and the length of the candle L(t).

1872_126.png

Problem 2.Figure 2 shows a membrane reactor where an enzyme-catalyzed reaction A →B occurs. The enzyme is immobilized in the membrane. The concentrations of the feed stream and product stream of A (CA) and B (CA) maintains as shown in the figure. A thin coating layer is applied in order to accelerate the diffusion of A to the membrane and restricts the flux of B across the layer and the flux is followed by858_126.png

NBz(h)=KcCB(h) where Kc is the permeability coefficient. The reaction is the Figure 2. Membrane reactor first-order and homogenous.

Derive the governing equations and boundary conditions to determine the concentrations of the reactant and product in the membrane.

Make the governing equations dimensionless and find the corresponding boundary conditions.

Problem 3. Two immiscible incompressible Newtonian fluids ( 1, 1for fluid1 and 2, 2for fluid2) flow between two infinite plates separated by a height H1 as shown below. The bottom plate is stationary, while the top moves at a constant velocity Vo. The Flow is steady and laminar.

 

431_126.png

Problem4. (10 points) Put the following vector-calculus forms into Tensor Notation form using the Kronecker delta and permutation symbol:

1810_126.png

433_126.png

Mechanical Engineering, Engineering

  • Category:- Mechanical Engineering
  • Reference No.:- M91869602

Have any Question?


Related Questions in Mechanical Engineering

Heat transfer and combustionyou will need graph paper a

HEAT TRANSFER AND COMBUSTION You will need graph paper, a calculator, a copy of Appendix 1 from lesson HTC - 4 - 2 and access to steam tables to answer this TMA. 1. A fuel gas consists of 75% butane (C 4 H 10 ), 10% prop ...

Materials behaviour from atoms to bridges assignment -

Materials Behaviour from Atoms to Bridges Assignment - Distributed loads and static equilibrium (Please note: you should show your steps with necessary figures) Q1. Two beam sections are jointed at C and supported at A b ...

Assignment -q1 explain the difference between the

Assignment - Q1. Explain the difference between the metacentric height of a ship during 'Partially Afloat condition and 'Free Floating' condition; aid a sketch to support your answer. Q2. With the aid of sketches, explai ...

Problem on shaft -assuming no frictional losses a torque of

Problem on Shaft - Assuming no frictional losses, a torque of T = 750lb·in is applied through the shaft of gear F in order to drive the roller chain at point B at a constant speed. The chain sprocket has a pitch diameter ...

Force exerted by jet on moving cart1 you need to determine

Force Exerted By Jet On Moving cart. 1. You need to determine the velocity of water that comes out from the nozzle of this system. need the equation please formulate the equation. 2. This water will strike a small cart a ...

Structural mechanics questions -q1 a 150-lb bucket is

Structural Mechanics Questions - Q1. A 150-lb bucket is suspended from a cable on the wooden frame. Determine the resultant internal loadings on the cross section at D, and at E. Q2. The shaft is supported at its ends by ...

The aim of the project is to demonstrate certain aspects of

The aim of the project is to demonstrate certain aspects of engineering materials in different applications. The projects will be assessed on the basis of a written Research Report. The report should clearly show what yo ...

Question - truss structureconsider the three membered

Question - Truss Structure Consider the three membered planar truss structure shown in the figure below. All members of the truss have identical square cross-sectional area (A) of 25 mm x 25 mm, and Youngs Modulus (E) = ...

Questions -q1 a qualitative estimate of the effect of a

Questions - Q1. A qualitative estimate of the effect of a wind-tunnel contraction (Figure) on turbulent motion can be obtained by assuming that the angular momentum of eddies does not change through the contraction. Let ...

The aim of the project is to demonstrate certain aspects of

The aim of the project is to demonstrate certain aspects of engineering materials in different applications. The projects will be assessed on the basis of a written Research Report. The report should clearly show what yo ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As