Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1: prepare down the expression of the function f (t) shifted by 'a'.

problem 2: When is the network N' a dual of the network N?

problem 3: Illustrate when the network is is stated to be linear?

problem 4: What is the number of various node pair voltage in the network which has 10 nodes and 17 branches? Illustrate the phase difference between the applied voltage and current in a circuit having 90 ohms resistance in series with the 90 ohms capacitive reactance?

problem 5: Thevenin’s theorem can be applied to compute current in what type of load?

problem 6: Find out the number of independent loops in a network having conventional transformer and 8 elements with 5 nodes?

problem 7: prepare the integral representation of the convolution of two functions f 1(t) and f 2(t).

problem 8: prepare down the transfer function of an electrical low pass RC network.

problem 9: A step voltage of 10V is applied at t = 0 in a series RC circuit where R = 10 ohms and C = 2F.The initial charge on capacitor is nil. Determine i(t).

problem 10: For the given network function, draw the pole zero diagram and therefore obtain the time domain response. Validate the result analytically.

V(s) = 5(s+5)/(S +2) (S + 7)

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M97669

Have any Question? 


Related Questions in Electrical & Electronics

Power mosfet breakdown voltage 800v must conduct 10a when

power mosfet breakdown voltage 800v must conduct 10A when on with a maximum on state voltage 4v.If the current density in the mosfet must be limited to 200A/cm,estimate the conduxting area

1 what is the determinant expansion for the curl of a

1. What is the determinant expansion for the curl of a vector? 2. What is the significance of the curl of a vector being equal to zero? 3. State Ampere's circuital law in differential form for the simple case of How is i ...

1 find the velocity with which the group of two frequencies

1. Find the velocity with which the group of two frequencies 2400 MHz and 2500 MHz travels in a parallel-plate waveguide of dimension a = 2.5 cm and having a perfect dielectric of 2. For a narrow-band amplitude modulated ...

A create a function that accepts as input argument a number

a. Create a function that accepts as input argument a number in radians and returns its value in degrees. b. Compute (through your function) how many degrees is p=4 radians. a. Create a function that plots the function s ...

Consider the simple rc circuit shown in fig p23-3 let r 1

Consider the simple RC circuit shown in Fig. P2.3-3. Let R = 1 kΩ and C = 1 nF. (a) Find the system transfer function. (b) Plot the magnitude and phase responses. (c) Show that a lowpass signal x(t) with bandwidth W « 10 ...

A causal n-point moving-average filter has impulse response

A causal N-point moving-average filter has impulse response h[n] = (u[n]-u[n-N])/N. a. Determine a constant coefficient difference equation that has impulse response h[n]. b. Write a MATLAB function that will compute the ...

An ltic system impulse response is given by ht ut-ut - 1a

An LTIC system impulse response is given by h(t) = u(t)-u(t - 1). a. Determine the transfer function H(s). Using H(s), determine and plot the magnitude response |H(jω)|. Which type of filter most accurately describes the ...

1 discuss the consequence of the frequency dependence of

1. Discuss the consequence of the frequency dependence of the phase velocity of a wave in a material medium. 2. What is loss tangent? Discuss its significance. 3. What is the intrinsic impedance of a material medium? Wha ...

1 fluid flows between two parallel plates a distance h

1. Fluid flows between two parallel plates, a distance h apart. The upper plate moves at velocity, v 0 ; the lower plate is stationary. For what value of pressure gradient will the shear stress at the lower wall be zero? ...

A dc source supplies an inverter with bipolar pwm control

A DC source supplies an inverter with bipolar PWM control. The effective value of the output voltage on the fundamental frequency of 50 Hz is 220 V. The load is a serial R-L connection with a resistance R = 10 Ω and an i ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro