Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

For the curved surface AB:

Q1. Find out the magnitude, direction and line of action of the vertical component of hydrostatic force acting on the surface. Here l = 1 m.

Q2. Find out the magnitude, direction and line of action of the horizontal component of the hydrostatic force acting on surface.

747_hydrostatic force.jpg

Physics, Academics

  • Category:- Physics
  • Reference No.:- M99664

Have any Question? 


Related Questions in Physics

At a depth of 10 meters in a freshwater lake answer the

At a depth of 10 meters in a freshwater lake, answer the following 1. what is the pressure in kPa due to the submersion in the water? (the correct answer is between 1 and 100) 2. What is the total pressure in kPa? (the c ...

An oscillating mass at the end of a spring is at a distance

An oscillating mass at the end of a spring is at a distance y from its equilibrium position given by The constant k measures the stiffness of the spring. (a) Find a time at which the mass is farthest from its equilibrium ...

1 the practical depth limit for a suited diver is about 185

1. The practical depth limit for a suited diver is about 185 m. What is the gage pressure in sea water at that depth? The specific gravity of sea water is 1.025. 2. Matter is attracted to the center of Earth with a force ...

White light is shone on a very thin layer of glass n 15 and

White light is shone on a very thin layer of glass (n= 1.5), and above the glass layer, interference maxima for two wavelengths (and no other in between) are seen: one green wavelength of 550 nm, and one orange wavelengt ...

A a persons blood pressure is measured to be 112 plusmn 5

(a) A person's blood pressure is measured to be 112 ± 5 mm Hg. What is its percent uncertainty? (Note that percent uncertainties should be reported to two significant figures.) WebAssign will check your answer for the co ...

Helium-3 he3 has potential to be used as fuel in future

Helium-3 (He3) has potential to be used as fuel in future nuclear fusion power plants. It would produce a clean fusion process, leaving little of the radioactive waste that plagues nuclear fission. But Helium-3 is found ...

Find the impurity concentrations necessary to dope the

Find the impurity concentrations necessary to dope the polysilicon gate so that the surface is flat-banded. V S =0, intrinsic, V S =V F , and at the threshold, V S =2V F . The last is known as the zero threshold device b ...

1 how far in terms of wavelength does a wave travel in 15

1. How far, in terms of wavelength, does a wave travel in 1.5 periods? 2. A ball is tossed upward so that it will be airborne for six seconds. a) Find the initial velocity. b) How high will it go? ( Hint: A the highest p ...

An alternating current i i0 cosomega t nbspflows down a

An alternating current I = I_0 cos(ω t)  flows down a long straight wire and returns along a coaxial conducting tube of radius a. (a) In what direction does the induced electric field point? (b) Assuming that the E-field ...

The speed of a wave in a string is given by v oumlftm

The speed of a wave in a string is given by v = Ö(FT/m), where FT is the tension in the string and m = mass / length of the string. A 2.00 m long string has a mass of 12.5 g. A 162 g mass is attached to the string and hu ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro