Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe some of the disadvantage of Paging System.

2) Describe what is meant by the term ‘ISDN’?

3) Describe the frequency range that is used for the music and speech signals?

4) describe what is Reverberation Time?

5) describe why is there requirement of ‘Scanning’ in the television?

6) Describe what is meant by “Pedestal Height” of the composite video signal.

7) describe the term ‘Perigee’ with respect to the satellite communication.

8) What is the requirement for the ‘Multiple Access Methods’?

9) describe the function of ‘Duplexer’?

10) describe the influence of ‘Doppler Effect’ in the CW Radar.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M912950

Have any Question? 


Related Questions in Electrical & Electronics

1 distinguish message authentication and entity

1. Distinguish message authentication and entity authentication. 2. Alice signs the message she sends to Bob to prove that she is the sender of the message. Which of the following keys does Alice need to use? a. Alice's ...

1 what is the voltage reflection coefficient at the short

1. What is the voltage reflection coefficient at the short circuit for a short-circuited line? 2. Can the transmitted wave current at the junction between two transmission lines be greater than the incident wave current? ...

1 how is the magnetic flux density defined in terms of

1. How is the magnetic flux density defined in terms of force on a current element? 2. How is the magnetic flux density defined in terms of force on a moving charge? 3. What are the units of the magnetic flux density? 4. ...

1 discuss the input behavior of a short-circuited line for

1. Discuss the input behavior of a short-circuited line for frequencies slightly beyond those for which the quasistatic approximation is valid. 2. What are the boundary conditions for the voltage and current at the junct ...

Data at a rate of 1 million pulses per second are to be

Data at a rate of 1 million pulses per second are to be transmitted over a certain communications channel. The unit step response g(t) for this channel is shown in Fig. P2.7-1. a. Can this channel transmit data at the re ...

A signal is bandlimited to 12 khz the band between 10 and

A signal is bandlimited to 12 kHz. The band between 10 and 12 kHz has been so corrupted by excessive noise that the information in this band is nonrecoverable. Determine the minimum sampling rate for this signal so that ...

1 what is a poynting vector what is its physical

1. What is a Poynting vector? What is its physical significance? 2. What is the physical interpretation of the surface integral of the Poynting vector over a closed surface? 3. Discuss how the fields far from a physical ...

1 find the minimum value of h for which the gate shown

1. Find the minimum value of h for which the gate shown will rotate counterclockwise if the gate cross section is (a) rectangular, 4 ft × 4 ft; (b) triangular, 4 ft at the base × 4 ft high. Neglect bearing friction. 2. A ...

1 show that the radiation fields given by equations 925a

1. Show that the radiation fields given by equations (9.25a) and (9.25b) do not by themselves satisfy both of Maxwell's curl equations. 2. Find the value of r at which the amplitude of the radiation field term in equatio ...

1 for the force field f x2ay find the approximate value of

1. For the force field F = x 2 ay, find the approximate value of the line integral of F from the origin to the point (1, 3, 0) along a straight line path by dividing the path into ten equal segments. 2. For the force fie ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro