Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1)  describe what is Per unit?

2) Specify what are the approximations formed in the Impedance Diagram

3) describe what is meant by the infinite bus?

4) Specify the quantities which are linked with the each bus within the system?

5) prepare down the relative frequency of the occurrence of several faults?

6) Sketch the zero sequence network of the delta/delta transformer.

7) Specify the fault where the positive, negative and zero sequence component currents are equal.

8) State any two methods of decreasing the short circuit current.

9) What do you meant by the stability?

10) Determine the frequency of the oscillation for synchronous coefficient of 0.6, inertia constant, H =4 and system frequency of 50 Hz.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913287

Have any Question? 


Related Questions in Electrical & Electronics

The rate at which metallic ions are electroplated from a

The rate at which metallic ions are electroplated from a dilute electrolytic solution onto a rotating disk electrode is usually governed by the mass diffusion rate of ions to the disk. This process is believed to be cont ...

In communication channels transmitted signal is propagated

In communication channels, transmitted signal is propagated simultaneously by several paths of varying lengths. This causes the signal to reach the destination with varying time delays and varying gains. Such a system ge ...

1 in logisim implement an 8-to-1 mux using 2 4-to-1 muxes

1. In Logisim implement an 8-to-1 MUX using 2 4-to-1 MUXes and a 2-to-1 MUX. 2. In Logisim implement an 8-to-1 MUX using 4 2-to-1 MUXes and a 4-to-1 MUX. 3. In Logisim implement a circuit similar to the one in figure 8-1 ...

1 discuss briefly the motional emf concept2 what is lenzs

1. Discuss briefly the motional emf concept. 2. What is Lenz's law? 3. How would you orient a loop antenna in order to obtain maximum signal from an incident electromagnetic wave which has its magnetic field linearly pol ...

A number equal to the sum of its coordinates is assigned to

A number equal to the sum of its coordinates is assigned to each point in a rectangular room having three of its contiguous edges as the coordinate axes. Draw a sketch of the constant-magnitude surfaces for the number fi ...

1 oil is supplied at the center of two long plates the

1. Oil is supplied at the center of two long plates. The volumetric flow rate per unit length is Q and the plates remain a constant distance, b, apart. Determine the vertical force per unit length as a function of the Q, ...

1 in transform coding show that a receiver that receives an

1. In transform coding, show that a receiver that receives an M matrix can create the original p matrix. 2. Calculate the T matrix for DCT when N = 1, N = 2, N = 4, and N = 8. 3. Using one-dimensional DCT encoding, calcu ...

Consider two bar elements under a force at the tip using

Consider two bar elements under a force at the tip. Using the displacement controlled method, plot the load-displacement curve (F vs. u 2  and u 3 ). Increase the tip displacement u 3  up to 1.0 m by ten equal increments ...

1 for flow at very low speeds and with large viscosity the

1. For flow at very low speeds and with large viscosity (the so-called creeping flows) such as occur in lubrication, it is possible to delete the inertia terms, Dv/Dt, from the Navier- Stokes equation. For flows at high ...

For each of the following baseband signals i mt cos 1000t

For each of the following baseband signals (i) m(t) = cos 1000t, (ii) m(t) = 2cos 1000t + cos 2000t, and (iii) m(t) = cos 1000t cos 3000t: a. Sketch the spectrum of m(t). b. Sketch the spectrum of the DSB-SC signal m(t) ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro