Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) Specify the benefits of the optical communication.

2) describe the skew rays.

3) describe the term group delay.

4) describe some of the causes for absorption?

5) What is meant by the population inversion?

6) Compare and contrast LED and LASER?

7)  Specify several kinds of the optical connector.

8) describe the use of rise time budget?

9) describe the LED transmitter with the help of diagram?

10) describe the significance of the pre-amplifier?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M912978

Have any Question? 


Related Questions in Electrical & Electronics

A continuous-time signal x t deltat 12 is sampled at

A continuous-time signal x (t) = Δ((t = 1)/2) is sampled at three rates: 10, 2, and 1 Hz. Sketch the resulting sampled signals. Because x (t) is timelimited, its bandwidth is infinite. However, most of its energy is conc ...

In a leaky bucket used to control liquid flow how many

In a leaky bucket used to control liquid flow, how many gallons of liquid are left in the bucket if the output rate is 5 gal/min, there is an input burst of 100 gal/min for 12 s, and there is no input for 48 s?

1 when a doublet is added to a uniform stream so that the

1. When a doublet is added to a uniform stream so that the source part of the doublet faces the stream, a cylinder flow results. Plot the streamlines when the doublet is reversed so that the sink faces the stream. 2. A 2 ...

1 what is the voltage reflection coefficient at the short

1. What is the voltage reflection coefficient at the short circuit for a short-circuited line? 2. Can the transmitted wave current at the junction between two transmission lines be greater than the incident wave current? ...

In a chord network with m 4 node n2 has the following

In a Chord network with m = 4, node N2 has the following finger-table values: N4, N7, N10, and N12. For each of the following keys, first find if N2 is the predecessor of the key. If the answer is no, find which node (th ...

1 what is meant by the dominant mode why are waveguides

1. What is meant by the dominant mode? Why are waveguides designed so that they propagate only the dominant mode? 2. Why is the dimension b of a rectangular waveguide generally chosen to be less than or equal to one-half ...

1 how would you use amperes circuital law in differential

1. How would you use Ampere's circuital law in differential form to find the magnetic field adjacent to the current sheet? 2. If the current density on the infinite plane current sheet of Figure 4.2 were directed in the ...

1 fluid flows between two parallel plates a distance h

1. Fluid flows between two parallel plates, a distance h apart. The upper plate moves at velocity, v 0 ; the lower plate is stationary. For what value of pressure gradient will the shear stress at the lower wall be zero? ...

For the following truth tablea give the dnf equation for

For the following truth table: a. Give the DNF equation for the table. b. Minimize the equation using a K-map. c. Show that the DNF is equivalent to the minimum representation using Boolean algebra.

1 assume alice needs to send a confidential signed document

1. Assume Alice needs to send a confidential signed document to 100 people. How many keys does Alice need to use to prepare 100 copies if she uses asymmetric-key confidentiality? Explain. 2. In a club with 50 members, ho ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen