Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe BIBO Stability in detail.

2) What do you mean by impulse response?

3) describe characteristic equation in detail.

4) describe how the roots of characteristic equation are related to stability?

5) prepare down the essential condition for stability.

6) describe the relation between stability and coefficient of characteristic polynomial.

7) Describe the nature of impulse response when roots of characteristic equation are lying on imaginary axis?

8) Describe the nature of impulse response if roots of characteristic equation are lying on right half s-plane?

9) What is principle of argument?

10) What is the necessary and sufficient condition for stability?

11) describe routh stability condition in detail with suitable ex.

12) What do you mean by auxiliary polynomial?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911032

Have any Question? 


Related Questions in Electrical & Electronics

A three-phase 60-hz induction motor has eight poles and

A three-phase, 60-Hz induction motor has eight poles and operates with a slip of 0.05 for a certain load. Determine a. The speed of the rotor with respect to the stator. b. The speed of the rotor with respect to the stat ...

The following 14 w resistors are in series 12 k omega 22 k

The following 1/4 W resistors are in series: 1.2 k Ω, 2.2 k Ω, 3.9 k Ω, and 5.6 k Ω. What is the maximum voltage that can be applied across the series resistors without exceeding a power rating? Which resistor will burn ...

The voltage across a 25- omega capacitive reactance is

The voltage across a 2.5- Ω capacitive reactance is given. What is the sinusoidal expression for the current? Sketch the v and i sinusoidal waveforms on the same set of axes

The circuit shown in figure p1534 exhibits low-pass

The circuit shown in Figure P15.34 exhibits low-pass, high-pass, and band-pass voltage gain characteristics, depending on whether the output is taken at node 1, node 2, or node 3. Find the transfer functions relating eac ...

Always show all the intermediate values that you can

Always show all the intermediate values that you can calculate.  If further calculations depend on a value that you can't figure out, just use a letter (like I R1 ) or a guessed value and proceed. 1. In the circuit shown ...

Design a comparator circuit to set off an alarm when the

Design a comparator circuit to set off an alarm when the temperature in a boiler reaches 160°C. You have available a temperature-to-voltage transducer which generates a voltage of 5 V at 160°C and an alarm which activate ...

A half-wave scr converter circuit is used to regulate the

A half-wave SCR converter circuit is used to regulate the power across a 10Ω resistance. When the triggering angle is 30°, the power consumed by the load is 500W. Compute the rms voltage of the source, and the average an ...

For the network of given figurea determine the currents is

For the network of given Figure: a. Determine the currents I s , I 1 , I 3 , and I 4 . b. Calculate V a and V bc .

An alternator is supplying a load of 300 kw at a pf of 06

An alternator is supplying a load of 300 kW at a p.f. of 0.6 lagging. If the power factor is raised to unity, how many more kilowatts can alternator supply for the same kVA loading ?

Suppose a clocked synchronous system in which registers

Suppose a clocked synchronous system, in which registers have setup time of 100ps and clock-to-output delay of 200ps, has a timing constraint that the clock frequency be 800MHz. Propagation delays through combinational e ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

A cola-dispensing machine is set to dispense 9 ounces of

A cola-dispensing machine is set to dispense 9 ounces of cola per cup, with a standard deviation of 1.0 ounce. The manuf

What is marketingbullwhat is marketing think back to your

What is Marketing? • "What is marketing"? Think back to your impressions before you started this class versus how you

Question -your client david smith runs a small it

QUESTION - Your client, David Smith runs a small IT consulting business specialising in computer software and techno

Inspection of a random sample of 22 aircraft showed that 15

Inspection of a random sample of 22 aircraft showed that 15 needed repairs to fix a wiring problem that might compromise

Effective hrmquestionhow can an effective hrm system help

Effective HRM Question How can an effective HRM system help facilitate the achievement of an organization's strate