Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe the Decimal to BCD Encoder by providing its truth table.

2) describe the Decimal to BCD Encoder by using 74147.

3) describe the Octal to Binary Encoder with the help of logic gates also draw the truth table.

4) Draw the block diagram of IC 74148. describe why they are known as the priority encoder.

5) Design the Hexadecimal to Binary Priority Encoder.

6) describe what is meant by a tri-state Buffer? Describe the function of IC 74245.

7) describe IC 74373 along with its block diagram.

8) describe what are Carry Look Ahead Adders? describe its advantages?

9) describe the schematic block diagram for 74181 ALU with suitable diagram.

10) Design the four- bit binary adder by using the IC 7483. 

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911899

Have any Question? 


Related Questions in Electrical & Electronics

Find the length of a hertzian dipole that would radiate the

Find the length of a Hertzian dipole that would radiate the same time-average power as the loop antenna of Problem 10.19 for the same current and frequency as in Problem 10.19. Problem 10.19 A circular loop antenna of ra ...

A dc pump connected to a pv module runs a garden water

A dc pump connected to a PV module runs a garden water fountain. The pump I -V curve and the hourly I -V curves for the module are shown. Once the pump starts running, it needs 8 V to keep spinning. At what time in the m ...

1 what is the basis behind the construction of the smith

1. What is the basis behind the construction of the Smith Chart? How does the Smith Chart simplify the solution of transmission-line problems? 2. Briefly discuss the mapping of the normalized line impedances from the com ...

1 consult an appropriate reference book and compare the

1. Consult an appropriate reference book and compare the procedure used for obtaining the electromagnetic field due to the Hertzian dipole with the procedure used here. 2. What are radiation fields? Why are they importan ...

A number equal to the sum of its coordinates is assigned to

A number equal to the sum of its coordinates is assigned to each point in a rectangular room having three of its contiguous edges as the coordinate axes. Draw a sketch of the constant-magnitude surfaces for the number fi ...

1 discuss how the superposition of two uniform plane waves

1. Discuss how the superposition of two uniform plane waves propagating at an angle to each other gives rise to a composite wave consisting of standing waves traveling bodily transverse to the standing waves. 2. What is ...

Objectivesthe objectives of this experiment are1 to

OBJECTIVES: The objectives of this experiment are: 1) To investigate the operation of automatic reset circuits. 2) To understand the difference between a positive edge triggered, negative edge triggered, and a level trig ...

For the euler beam element shown in the figure derive the

For the Euler beam element shown in the figure, derive the interpolation functions, N I (ξ), stiffness matrix, k, and nodal force vector, f. Assume that the uniformly distributed load is  f (x) = f. Note that the referen ...

1 briefly outline the procedure involved in the successive

1. Briefly outline the procedure involved in the successive solution of Maxwell's equations. 2. How does the technique of successive solution of Maxwell's equations reveal the interaction between the electric and magneti ...

1 oil is supplied at the center of two long plates the

1. Oil is supplied at the center of two long plates. The volumetric flow rate per unit length is Q and the plates remain a constant distance, b, apart. Determine the vertical force per unit length as a function of the Q, ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro