Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe the term Holding current. Specify it in detail.

2) describe why the Power MOSFET is said to be the voltage controlled device.?

3) describe the function of freewheeling diode within the controlled rectifiers?

4) describe the term Firing angle.

5) describe the term duty cycle of the dc choppers.

6) Specify the two methods of the control within the AC voltage controllers?

7) Distinguish between the VSI and CSI.

8) Describe the term modulation index of the PWM. describe some of its use?

9) Specify the merits and de-merits of the HVDC transmission.

10) describe some of the benefits of the online UPS.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913294

Have any Question? 


Related Questions in Electrical & Electronics

1 obtain the equations for a one-dimensional steady viscous

1. Obtain the equations for a one-dimensional steady, viscous, compressible flow in the x direction from the Navier- Stokes equations. (These equations, together with an equation of state and the energy equation, may be ...

1 state amperes circuital law2 what are the units of the

1. State Ampere's circuital law. 2. What are the units of the magnetic field intensity vector? 3. What are the units of the displacement flux density vector? 4. What is displacement current? Give an example involving dis ...

A hertzian dipole is situated parallel to a corner

A Hertzian dipole is situated parallel to a corner reflector, which is an arrangement of two plane, perfect conductors at right angles to each other, as shown by the crosssectional view in Figure 9.19. (a) Locate the ima ...

The rate at which metallic ions are electroplated from a

The rate at which metallic ions are electroplated from a dilute electrolytic solution onto a rotating disk electrode is usually governed by the mass diffusion rate of ions to the disk. This process is believed to be cont ...

1 state faradays law in differential form for the general

1. State Faraday's law in differential form for the general case of an arbitrary electric field. How is it derived from its integral form? 2. What is meant by the net right-lateral differential of the x- and y-components ...

1 why is it necessary to have the minus sign associated

1. Why is it necessary to have the minus sign associated with the time rate of increase of magnetic flux on the right side of Faraday's law? 2. What is electromotive force? 3. What are the different ways in which an emf ...

A line assumed to be infinitely long and of unknown

A line assumed to be infinitely long and of unknown characteristic impedance when connected to a line of characteristic impedance 50 Ω produces a standing wave ratio of value 2 in the 50-Ω line. The same line when connec ...

A voltage source vt 100 cos2pi50 t v is applied to a

A voltage source v(t) = 100 cos(2π50 t) [V] is applied to a nonlinear load, resulting in non-sinusoidal current: i(t) = 4 + 10 cos(2π50 t +30°) + 20 cos (4π50 t +45°) [A]. Determine: (a) the power absorbed on the load, ( ...

1 for flow at very low speeds and with large viscosity the

1. For flow at very low speeds and with large viscosity (the so-called creeping flows) such as occur in lubrication, it is possible to delete the inertia terms, Dv/Dt, from the Navier- Stokes equation. For flows at high ...

Discretize the continuous-time system with transfer

Discretize the continuous-time system with transfer function H(s) = (s + 10 )/s with use of the bilinear (Tustin) approximation method. Verify your result by converting the computed discrete-time system to continuous-tim ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro