Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) prepare down the types of array? describe them in detail.

2) describe Broad side array in detail.

3) Describe End fire array with detailed explanation.

4) What do you mean by collinear array?

5) prepare down the condition on phase for end fire array with increased directivity.

6) What do you mean by array factor?

7) Describe beam width of major lobe.

8) prepare down the expression of beam width for broad side array and end fire array.

9) With neat sketch, describe the operation of helical antenna?

10) Get the expression for field and radiation pattern produced by 2 element array of infinitesimal with distance of separation 1/2 and currents of unequal magnitude and phase shift 180 degree?

11) Deduce the expression for far field components of a small loop antenna.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911163

Have any Question? 


Related Questions in Electrical & Electronics

Figure 3013 shows a router using priority queuing at the

Figure 30.13 shows a router using priority queuing at the input port. The arrival and required service times (transmission time is negligible) for 10 packets are shown below; ti means that the packet has arrived i ms aft ...

1 rework problem with the assumption that the momentum of

1. Rework Problem with the assumption that the momentum of the incoming air at section (1) is zero. Determine the exit velocity, v, and the magnitude of the pressure drop at section (1). 2. Air of density 1.21 kg/m 3  is ...

A the highest frequency in the spectrum x omega fig p81-8a

a. The highest frequency in the spectrum X (ω) (Fig. P8.1-8a) of a bandpass signal x (t) is 30 Hz. Hence, the minimum sampling frequency needed to sample x (t) is 60 Hz. Show the spectrum of the signal sampled at a rate ...

1 the rocket nozzle shown below consists of three welded

1. The rocket nozzle shown below consists of three welded sections. Determine the axial stress at junctions 1 and 2 when the rocket is operating at sea level. The mass flow rate is 770 lb m /s. 2. The pressure on the con ...

1 when a doublet is added to a uniform stream so that the

1. When a doublet is added to a uniform stream so that the source part of the doublet faces the stream, a cylinder flow results. Plot the streamlines when the doublet is reversed so that the sink faces the stream. 2. A 2 ...

For each of the following baseband signals i mt cos 1000t

For each of the following baseband signals (i) m(t) = cos 1000t, (ii) m(t) = 2cos 1000t + cos 2000t, and (iii) m(t) = cos 1000t cos 3000t: a. Sketch the spectrum of m(t). b. Sketch the spectrum of the DSB-SC signal m(t) ...

A line assumed to be infinitely long and of unknown

A line assumed to be infinitely long and of unknown characteristic impedance is connected to a line of characteristic impedance on which standing wave measurements are made. It is found that the standing wave ratio is 3 ...

A square loop of wire of sides 001 m lies in the xy-plane

A square loop of wire of sides 0.01 m lies in the xy-plane, with its sides parallel to the x- and y-axes and with its center at the origin. It carries a current of 1 A in the clockwise sense as seen along the positive z- ...

1 outline the steps involved in the magnetostatic field

1. Outline the steps involved in the magnetostatic field analysis of a parallel plate structure and the determination of its inductance. 2. Outline the steps involved in the electromagnetostatic field analysis of a paral ...

A module with 40 cells has an idealized rectangular i-v

A module with 40 cells has an idealized, rectangular I-V curve with I SC = 4 A and V OC = 20 V. If a single cell has a parallel resistance of 5Ω and negligible series resistance, draw the I-V curve if one cell is complet ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro