Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) What do you mean by an antenna? describe in detail.

2) What do you understand by radiation pattern?

3) Describe Radiation intensity in detail.

4) Describe Beam efficiency in detail.

5) describe Directivity in detail.

6) prepare down the various kinds of aperture.

7) Describe various types of aperture in detail.

8) describe Aperture efficiency with detailed explanation.

9) What do you understand by effective height?

10) What do you understand by the field zone? describe in detail.

11) What do you understand by Polarization?

12) What do you understand by front to back ratio?

13) Describe antenna efficiency in detail.

14) What do you mean by radiation resistance?

15) What do you understand by antenna beam width?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911157

Have any Question? 


Related Questions in Electrical & Electronics

1 what is the brewster angle what is the polarization of

1. What is the Brewster angle? What is the polarization of the reflected wave for an elliptically polarized wave incident on a dielectric interface at the Brewster angle? Discuss an application of the Brewster angle effe ...

A dc source supplies an inverter with bipolar pwm control

A DC source supplies an inverter with bipolar PWM control. The effective value of the output voltage on the fundamental frequency of 50 Hz is 220 V. The load is a serial R-L connection with a resistance R = 10 Ω and an i ...

An oscillator by definition is a source no input that

An oscillator by definition is a source (no input) that generates a sinusoid of a certain frequency ω0. Therefore an oscillator is a system whose zero-input response is a sinusoid of the desired frequency. Find the trans ...

A thin rod of diameter d is pulled at constant velocity

A thin rod of diameter d is pulled at constant velocity through a pipe of diameter D. If the wire is at the center of the pipe, find the drag per unit length of wire. The fluid filling the space between the rod and the i ...

1 state the divergence theorem and discuss its application2

1. State the divergence theorem and discuss its application. 2. What is the divergence of the curl of a vector? 3. Summarize Maxwell's equations in differential form. 4. Are all Maxwell's equations in differential form i ...

Load flow calculation -in the power network shown below

Load Flow Calculation - In the power network shown below, node 1 is the slack bus, where the nodal voltage is defined as (1.0∠0 o ) pu, nodes 2, 4 and 5 are load buses, and node 3 is a generator bus where the voltage mag ...

1 how would you use amperes circuital law in differential

1. How would you use Ampere's circuital law in differential form to find the magnetic field adjacent to the current sheet? 2. If the current density on the infinite plane current sheet of Figure 4.2 were directed in the ...

1 draw the symbols for the nand nor xor and xnor gates what

1. Draw the symbols for the NAND, NOR, XOR, and XNOR gates. What is the difference between the Buffer, AND, OR, XOR and the NOT, NAND, NOR, and XNOR gates? 2. Modify the circuit from question 2 to use a second AND gate o ...

A transmission line of length 2 m having a nonmagnetic

A transmission line of length 2 m having a nonmagnetic perfect dielectric is short-circuited at the far end. A variable-frequency generator is connected at its input and the current drawn is monitored. It is found that t ...

1 a 16-scale model of a torpedo is tested in a water tunnel

1. A 1/6-scale model of a torpedo is tested in a water tunnel to determine drag characteristics. What model velocity corresponds to a torpedo velocity of 20 knots? If the model resistance is 10 lb, what is the prototype ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen