Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1: What do you mean by transit time? Why it becomes a limiting factor at lug her frequencies?

problem 2: Describe different kinds of vacuum tubes in lieu of their weakness and strengths.

problem 3: What can be the probable solutions to the limitations of conventional tubes at high frequencies? Which one is the most excellent?

problem 4: describe the principle of the working of Klystron.

problem 5: Why are multicavity klystron and reflex klystron mainly used for entirely different application?

problem 6: A two cavity klystron amplifier has the given parameters:

V0 = 1000V, R0 = 40Kohm, I0 = 25mA, Freq = 3GHz,
Gap-spacing (d) =1mm,
Cavities-spacing = 4cm,
Effective shunt impedance, excluding beam loading = 30K ohm.

a) Determine the input gap voltage to give maximum voltage V2.
b) Determine the voltage gain and efficiency of the amplifier neglecting the beam loading.

problem 7: Why a microwave is termed as Microwave?

problem 8: What do you mean by frequency range of microwave? What limits the frequency of microwaves?

problem 9: prepare down the various bands in microwave range all along with the corresponding frequencies.

problem 10: Enlist the benefits of microwave frequencies over the lower frequency waves.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M97429

Have any Question? 


Related Questions in Electrical & Electronics

You are to size a grid-connected south-facing pv system for

You are to size a grid-connected south-facing PV system for Las Vegas to deliver 4000 kWh/yr. Use a tilt equal to latitude minus 15°. a. What should be the ac-rated power of the PV/inverter system? b. What temperature de ...

An output interface in a switch is designed using the leaky

An output interface in a switch is designed using the leaky bucket algorithm to send 8000 bytes/s (tick). If the following frames are received in sequence, show the frames that are sent during each second. ? Frames 1, 2, ...

1 distinguish between bound electrons and free electrons in

1. Distinguish between bound electrons and free electrons in an atom. 2. Briefly describe the phenomenon of conduction. 3. State Ohms' law applicable at a point. How is it taken into account in Maxwell's equations? 4. Br ...

1 state the divergence theorem and discuss its application2

1. State the divergence theorem and discuss its application. 2. What is the divergence of the curl of a vector? 3. Summarize Maxwell's equations in differential form. 4. Are all Maxwell's equations in differential form i ...

Consider the simple rc circuit shown in fig p23-3 let r 1

Consider the simple RC circuit shown in Fig. P2.3-3. Let R = 1 kΩ and C = 1 nF. (a) Find the system transfer function. (b) Plot the magnitude and phase responses. (c) Show that a lowpass signal x(t) with bandwidth W « 10 ...

Using the navier-stokes equations in appendix e solve

Using the Navier-Stokes equations in Appendix E, solve Problem. Problem The device in the schematic diagram below is a viscosity pump. It consists of a rotating drum inside of a stationary case. The case and the drum are ...

In a chord network using dht with m 4 draw the identifier

In a Chord network using DHT with m = 4, draw the identifier space and place 4 peers with node ID addresses N3, N8, N11, and N13 and three keys with addresses k5, k9, and k14. Determine which node is responsible for each ...

Question 1 a road 300 m long is required to be illuminated

Question 1. A road 300 m long is required to be illuminated by providing 40W fluorescent lamps. The width of the road is 4m. Design a street lighting scheme for obtaining minimum level of illumination of 0.6 lux assuming ...

You are to size a grid-connected south-facing pv system for

You are to size a grid-connected south-facing PV system for Las Vegas to deliver 4000 kWh/yr. Use a tilt equal to latitude minus 15°. a. What should be the ac-rated power of the PV/inverter system? b. What temperature de ...

1 how would you characterize a transverse magnetic wave2

1. How would you characterize a transverse magnetic wave? 2. Compare the phenomenon of guiding of uniform plane waves in a parallel-plate waveguide with that in a parallel-plate transmission line.

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro