Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

Answer the following problems.

problem 1) Describe the function of ALU of 8085.

problem 2) What are the various registers in 8085? Describe their uses.

problem 3) Classify 8085 instructions in different groups.

problem 4) prepare the assembly language program for subtracting two 8-bit numbers.

problem 5) Draw a diagram for memory I/O interfacing and describe.

problem 6) Describe serial Data transfer.

problem 7) Draw the pin configuration of PPI chip 8255.

problem 8) Demonstrate interface connections are to measure and control temperature employing a microprocessor-based system.

problem 9) Draw the pin configuration of 8085 and describe the function of each pin.

problem 10) Describe different addressing modes of 8085 and their classification with exs.

problem 11) describe the different types of instructions available in 8085 by giving their format.

problem 12) List and describe the following with suitable ex.

(i) Mnemonics used for arithmetic operations.

(ii) Mnemonics used for logical operations.

problem 13) prepare the 8085 assembly language program to add two 8 bit numbers residing in memory and to store result in memory with suitable exs.

problem 14) describe data transfer schemes.

problem 15) Sketch the block diagram of 8255 Programmable Peripheral Interface (PPI) and describe its function and different modes of programming.

problem 16) prepare a program with flow chart to interface stepper motor with 8085.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M96995

Have any Question? 


Related Questions in Electrical & Electronics

1 in pastry assume the address space is 16 and that b 2

1. In Pastry, assume the address space is 16 and that b = 2. How many digits are in an address space? List some of the identifiers. 2. In a Pastry network with m = 32 and b = 4, what is the size of the routing table and ...

1 describe the phenomenon of the bouncing back and forth of

1. Describe the phenomenon of the bouncing back and forth of transient waves on a transmission line excited by a constant voltage source in series with internal resistance and terminated by a resistance. 2. Discuss the v ...

The operations and or and not are universal in that any

The operations AND, OR, and NOT are universal in that any Boolean function can be implemented using just these three gates. a. Prove by construction that the NAND gate is universal by creating AND, OR, and NOT gates usin ...

1 discuss the general solutions for the line voltage and

1. Discuss the general solutions for the line voltage and current in time-domain and the notation associated with their representation in concise form. 2. What is the fundamental distinction between the occurrence of the ...

The device in the schematic diagram below is a viscosity

The device in the schematic diagram below is a viscosity pump. It consists of a rotating drum inside of a stationary case. The case and the drum are concentric. Fluid enters at A, flows through the annulus between the ca ...

1 explain why rtp cannot be used as a transport-layer

1. Explain why RTP cannot be used as a transport-layer protocol without being run on the top of another transport-layer protocol such as UDP. 2. Both TCP and RTP use sequence numbers. Do sequence numbers in these two pro ...

1 discuss with the aid of an example the discharging of an

1. Discuss with the aid of an example the discharging of an initially charged line into a resistor. 2. Discuss the bounce-diagram technique of transient analysis of a line with uniform initial voltage and current distrib ...

1 we discuss the use of sip in this chapter for audio is

1. We discuss the use of SIP in this chapter for audio. Is there any drawback to prevent using it for video? 2. Assume two parties need to establish IP telephony using the service of RTP. How can they define the two ephe ...

A sinusoid cosomega0t is a bandpass signal with zero

A sinusoid cos(ω0t) is a bandpass signal with zero bandwidth. This implies that the sampling rate that will allow reconstruction of this signal from its samples can be arbitrarily small. Show that this is indeed the case ...

Approximate using a number of terms of your choice through

Approximate (using a number of terms of your choice) through the three forms of Fourier series expansion the periodic signal that is depicted in the following figure Each time, a. Plot the approximate signal in time of t ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen